Kenwood KMM-BT304 Instruction Manual - Page 31
Basic procedure, How to remove the unit, Installing the unit in-dash mounting, Part list
View all Kenwood KMM-BT304 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
INSTALLATION/CONNECTION Part list for installation (A) Faceplate (B) Trim plate Installing the unit (in-dash mounting) (C) Mounting sleeve (D) Wiring harness (E) Extraction key Hook on the top side Orientate the trim plate as illustrated before fitting. Basic procedure 1 Remove the key from the ignition switch, then disconnect the [ terminal of the car battery. 2 Connect the wires properly. See Wiring connection. ( 28) 3 Install the unit to your car. See Installing the unit (in-dash mounting). 4 Connect the [ terminal of the car battery. 5 Press to turn on the power. 6 Detach the faceplate and reset the unit within 5 seconds. ( 3) How to remove the unit 1 Detach the faceplate. 2 Remove the trim plate. 3 Insert the extraction keys deeply into the slots on each side, then follow the arrows as shown on the illustration. Do the required wiring. ( 28) Dashboard of your car Bend the appropriate tabs to hold the mounting sleeve firmly in place. ENGLISH 27