Kenwood KMR-D772BT Instruction manual - Page 40

TROUBLESHOOTING REFERENCES Bluetooth® Symptom "DEVICE FULL" "N/A VOICE TAG" "NOT SUPPORT" "NO ENTRY"/"NO PAIR" "ERROR" "NO INFO"/"NO DATA" "HF ERROR XX"/ "BT ERROR" "SWITCHING NG" Remedy The number of registered devices has reached its limit. Retry after deleting an unnecessary device. ( 25, DEVICE DELETE) Make sure the same voice as the registered voice tag is used. The connected phone does not support Voice Recognition feature or phonebook transfer. There is no registered device connected/found via Bluetooth. Try the operation again. If "ERROR" appears again, check if the device supports the function you have tried. Bluetooth device cannot get the contact information. Reset the unit and try the operation again. If this does not solve the problem, consult your nearest service center. The connected phones might not support phone switching feature. Maintenance Cleaning the unit Wipe off dirt on the faceplate with a dry silicone or soft cloth. Cleaning the connector Detach the faceplate and clean the connector gently with a cotton swab, being careful not to damage the connector. Connector (on the reverse side of the faceplate) Handling discs • Do not touch the recording surface of the disc. • Do not stick tape etc. on the disc, or use a disc with tape stuck on it. • Do not use any accessories for the disc. • Clean from the center of the disc and move outward. • Clean the disc with a dry silicone or soft cloth. Do not use any solvents. • When removing discs from this unit, pull them out horizontally. • Remove burrs from the center hole and disc edge before inserting a disc. More information For: - Latest firmware updates and latest compatible item list - KENWOOD original application - Any other latest information Visit . General • This unit can only play the following CDs: • For detailed information and notes about the playable audio files, visit . 36 ENGLISH