Kenwood KRC-25RA User Manual - Page 27

Installation s Removing the hard rubber frame 1 Engage the catch pins on the removal tool and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Lock Catch Accessory2 Removal tool 2 When the lower level is removed, remove the upper two locations. s Removing the Unit 1 Refer to the section "Removing the hard rubber frame" and then remove the hard rubber frame. 2 Remove the screw (M4´8) on the back panel. 3 Insert the two removal tools deeply into the slots on each side, as shown. Screw (M4X8) (commercially available) 4 Lower the removal tool toward the bottom, and pull out the unit halfway whilst pressing towards the inside. Catch facing up Accessory2 Removal tool NOTE The frame can be removed from the top side in the same manner. 2CAUTION Be careful to avoid injury from the catch pins on the removal tool. 5 Pull the unit all the way out with your hands, being careful not to drop it. - 27 -