Kenwood KRC-25RA User Manual - Page 29

Troubleshooting Guide PROBLEM The TEL mute function does not work. The TEL mute function turns on even though the TEL mute cable is not connected. POSSIBLE CAUSE The TEL mute cable is not connected properly. The TEL mute cable is touching a metal part of the car. SOLUTION Connect the cable correctly, referring to the section on "Connecting Cables to Terminals". Pull the TEL mute cable away from the metal part of the car. External disc control mode PROBLEM POSSIBLE CAUSE The disc control mode cannot be selected. The specified disc does not play, but another one plays instead. No cable has been connected to the disc changer input terminal on the unit. The specified CD is very dirty. The CD is upside-down. The disc is loaded in a different slot from that specified. The sound skips. The disc is severely scratched. Something is touching the disc changer. The CD is scratched or dirty. The display shows that the changer is being played, but no sound can be heard. The specified track does not play. Cannot play CD-R or CD-RW The computer chip in the unit is not functioning normally. Random play or magazine random play has been selected. Finalization processing is not being conducted for CDR/CD-RW. A non-compatible CD changer is being used to play the CD-R/CD-RW. SOLUTION Connect the cable to the disc changer input terminal on the unit. Clean the CD. Load the CD with the labelled side up. Eject the disc magazine and check the number for the specified disc. Try another disc instead. Remove whatever is touching it. If skipping happens at the same place when the car is stopped, something is wrong with the CD. Clean the CD. Press the reset button on the unit (see page 4). Turn off the random play or magazine random play function. Conduct finalization processing with CD recorder. Use a CD changer compatible with CD-R/CD-RW to play. If the following situations, consult your nearest service centre: • Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer Mode. • Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the AUX Mode is entered when switching modes. - 29 -