Kenwood SW10 Instruction Manual - Page 6
Connecting the subwoofer to the subwoofer non-fader output of the center unit, Examples - ksc 7
UPC - 019048175748
View all Kenwood SW10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ENGLISH Connecting the subwoofer to the subwoofer (non-fader) output of the center unit Front speaker Center unit KSC-SW10 RCA cord (Commercially available parts) 9 RCA cord When the center unit output is a single RCA jack, use an RCA cord that converts the output into the two RCA jacks as shown above. The subwoofer output will be halved if the conversion cord is not used. Connect the subwoofer to the subwoofer output (non-fader output) or the RCA jacks for the front output of the center unit. Notes: • Read the instruction manuals for the connected components such as the center unit as well as this instruction manual. • Please purchase an RCA cord that is commercially available separately. Use the provided RCA cord 9 for connection between the subwoofer and the separately purchased RCA cord. • When the center unit incorporates a DSP, connect the subwoofer to the subwoofer output (non-fader output) or to the RCA jacks for the front output. Do not connect to the RCA jacks for the rear output, as the low-frequency reproduction effect may be attenuated due to the DSP effect. Examples The following shows a typical connection for effective car stereo enjoyment. Connect your system by referring to the example. Caution: Under any circumstances, never apply inputs to the hashed terminals A and B simultaneously. POWER/SPEAKER REMOTE INPUT LINE IN L R Caution: Cover unused terminals with insulation tape to avoid short circuits. If there is no power control terminal in the center unit, connect the blue/white wire to the accessory line (ignition key switch ACC position line). Blue/White Fuse 10A Yellow Yellow If buzzing noise is heard from the speakers when the engine is running, attach a line noise filter (commercially available) to the power lead. 6 10-pin connector cord Car fuse box RCA cord (Commercially available parts) 9 RCA cord Ignition key switch Car fuse box (Main fuse) English Battery Center unit (SUB WOOFER OUT, Non-fader output) Caution: Connect the black lead wire ground terminal directly with a screw to an unpainted metal part of the vehicle. Turning the power ON without connecting this terminal is linked to damage of the stereo system. Be sure to connect it. Also, painted metal panels etc., are not grounded and will not function correctly. Be careful.