Kenwood SW10 Instruction Manual - Page 7
Installation
UPC - 019048175748
View all Kenwood SW10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH Installation Before fixing the speaker in its position, be sure to check the sound while it is connected preliminary. Caution: • Install in a location that does not come in the way of driving, getting in or out of the vehicle and movement inside the vehicle compartment. • Fix the product firmly so that it will not be moved by vibrations or impacts during driving. Fixing the cord in place 3 Fixture C 4 Machine screw x 2 6 10-pin connector cord 9 RCA cord 8 Remote control (Fig. 1) Fixing the subwoofer Flat installation 1 4 Machine screw x 4 1 Fixture A x 2 (Fig. 2) 1 Connect the 10-pin connector cord 6, RCA cord 9, and remote control 8 to the speaker unit. (Fig. 1) (When connecting the speaker input terminal, RCA cord is not necessary.) (The cords to be connected depends on the system. Refer to Connection of example.) 2 Fix the cords to the speaker unit with fixture C 3, and fix in place with the machine screws 4. (Fig. 2) Side installation 1 Caution: This portion becomes slightly hotter than other portions because it functions as the radiator of the heat generated by the amplifier. Attach the fixtures A 1 to the speaker unit securely using the machine screws 4. Be careful so that the connected cords do not get in between the speaker unit and fixtures A 1. 5 Tapping screw x 4 2 Holes not used 4 Machine screw x 6 2 Fixture B x 2 Holes not used Adjust the installation height so that the speaker unit will not rattle, and attach the bracket B 2 to the subwoofer using the machine screws 4. 2 5 Tapping screw x 6 Drill six pilot holes for ø3.6 mm screws. Drill four pilot holes for ø3.6 mm screws. Drill the pilot holes for φ3.6 mm screws on the sheet metal section of the vehicle , and attach the speaker unit to the vehicle using the tapping screws 5. Installing the remote control unit Install the remote control unit on the vehicle by the provided Velcro tape. 8 Remote Vehicle control 7 Velcro tape (Harder surface) 7 Velcro tape (Softer surface) Rear panel 2 Fixture B x 2 Drill the pilot holes for φ3.6 mm screws on the sheet metal section of the vehicle, and attach the speaker unit to the vehicle using the tapping screws 5. Caution: Install the remote control unit in a position that does not come in the way of driving operations. Avoid installing it in a place subject to direct sunlight or direct hot wind from the heater. Otherwise, the product may be degraded and a fire hazard may result. Remove dirt from the installation position before attaching the Velcro tape. When the Velcro tape is attached on the remote control unit, it cannot be accommodated in the main unit. English