Kenwood TK-2140 User Manual - Page 11

place to prevent accidentally

Get Kenwood TK-2140 PDF manuals and user guides View all Kenwood TK-2140 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

INSTALLING/ REMOVING THE (OPTIONAL) RECHARGEABLE BATTERY PACK OR ALKALINE BATTERY CASE 1 Match the guides of the battery pack with the corresponding grooves on the upper rear of the transceiver, then firmly press the battery pack to lock it in place. 2 Flip the safety catch into place to prevent accidentally pressing the release latch and removing the battery. 3 To remove the battery pack, lift the safety catch, press the release latch, then pull the battery pack away from the transceiver. Note: ◆ To lift the battery pack safety catch, use a piece of hardened plastic or metal, such as a screwdriver, that is no more than 6 mm wide and 1 mm thick. It is imperative that you place the implement under only the lip of the safety catch so that you do not damage the release latch. ◆ Before charging a battery pack that is attached to the transceiver, ensure that the safety catch is firmly closed. ◆ While operating the transceiver using a Li-ion or Ni-MH battery pack in areas with an ambient temperature of -10°C/ +14°F and lower, operating time may be shortened. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
7
I
NSTALLING
/ R
EMOVING
THE
(O
PTIONAL
) R
ECHARGEABLE
B
ATTERY
P
ACK
OR
A
LKALINE
B
ATTERY
C
ASE
1
Match the guides of the
battery pack with the
corresponding grooves on
the upper rear of the
transceiver, then firmly press
the battery pack to lock it in
place.
2
Flip the safety catch into
place to prevent accidentally
pressing the release latch
and removing the battery.
3
To remove the battery pack,
lift the safety catch, press the
release latch, then pull the
battery pack away from the
transceiver.
Note:
◆
To lift the battery pack safety catch, use a piece of hardened
plastic or metal, such as a screwdriver, that is no more than
6 mm wide and 1 mm thick.
It is imperative that you place the
implement under only the lip of the safety catch so that you do
not damage the release latch.
◆
Before charging a battery pack that is attached to the transceiver,
ensure that the safety catch is firmly closed.
◆
While operating the transceiver using a Li-ion or Ni-MH battery
pack in areas with an ambient temperature of °10
°
C/ +14
°
F and
lower, operating time may be shortened.