Kenwood TM-D700E User Manual 1 - Page 68
Programmable Function Pf Keys
View all Kenwood TM-D700E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
PROGRAMMABLE FUNCTION (PF) KEYS The Programmable Function keys are [PF], [MR], [VFO], and [CALL] located on the face of the microphone. These keys have the following default functions: [PF] (PF1) Band Select [MR] (PF2) Memory Recall [VFO] (PF3) VFO Select [CALL] (PF4) Call Channel Select (TM-D700E: 1750 Hz Tone TX) If you prefer, you can change the defaults to the following key functions: Key Function Ref. Page Key Function Ref. Page Key Function Ref. Page 13 A/B 17 MONITOR 19 REV LOW 33 STEP 64 21 VISUAL 48 ENTER VOICE 30,37, 56,63 83 MUTE CTRL 72 DIM 65 17 SUB-BAND SEL 17 1750 32 PM IN 44 DX (6) PM 44 A.B.C. 66 MENU 22 MsV 40 TNC LIST (4,6,11) (15) VFO 15 M. IN 36 P. MON (26) MR 37 C. IN 39 BCON (25,32) CALL 39 LOCK 67 MSG (30 ~ 32) MHz 20 T. SEL 30,55,57 POS (19,20) TONE 30,55,57 SHIFT 29 PWR (PF1only) 19 For the shaded functions, see the separate manual, "SPECIALIZED COMMUNICATIONS". 62 1 Press [MNU] to enter Menu mode. 2 Press [c]/ [d] to select "RADIO (1-)", then press [OK]. 3 Press [c]/ [d] to select "MIC (1-8-)", then press [OK]. 4 Press [c]/ [d] to select "PF1 (1-8-1)" to "PF4 (1-8-4)", then press [OK]. 5 Press [c]/ [d] to select the desired function. 6 Press [OK] to complete the setting. 7 Press [MNU] to exit Menu mode. After switching the power OFF, you may press Mic [PF]+ POWER ON. This allows you to skip steps 1 to 4. Press Mic [MR], [VFO], or [CALL] instead of [PF] as necessary. Note: x Without an optional VS-3 unit installed or with OFF selected in Menu 1-2-4 (VOICE), pressing the PF key programmed with Voice causes the transceiver to announce the current frequency using beeps of different frequencies. x To restore the default functions, perform Full Reset {page 41}.