Kenwood TM-D700E User Manual 1 - Page 77
Power-on Message, Display Demonstration
View all Kenwood TM-D700E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
POWER-ON MESSAGE Each time you switch the transceiver ON, "HELLO !!" appears and stays for approximately 2 seconds. You can program your favorite message in place of the factory default. 1 Press [MNU] to enter Menu mode. 2 Select Menu 1-1-1 (POWER-ON MSG), then press [OK]. • The display for entering a message appears; the first digit blinks. 3 Turn the Tuning control to select a character. • You can enter alphanumeric characters plus special ASCII characters. 4 Press [a]. • The cursor moves to the next digit. 5 Repeat steps 3 and 4 to enter up to 8 digits. Switches among the sets of alphanumeric characters, accented letters (TM-D700E only), and special ASCII characters. Switches between small and capital letters. Cancels Message Entry. Deletes the digit at which the cursor is blinking. Causes the cursor to move backward. Inserts the currently Clears all digits and selected character. (left BAND backs the cursor to SEL) the first digit. 6 Press [OK] to complete the setting. 7 Press [MNU] to exit Menu mode. The keypad on the MC-53DM also is available to enter alphanumeric characters in step 3. See page 18. DISPLAY DEMONSTRATION By initiating this function, various preprogrammed displays appear. You still can normally use the 14 transceiver in this mode. Pressing a front panel button or Mic key, or turning the Tuning control restores the operating display immediately. If there is no button/key entry or Tuning control adjustment for approximately 10 seconds, the transceiver reverts back to Demonstration mode. Press [F]+ POWER ON to switch the function ON (or OFF). 71