KitchenAid KBSN702MPA Owners Manual - Page 6
Shelves and Shelf Frames, Pull Out Tray, Marinating Pan, Remove and Replace the Top Drawer Cover
View all KitchenAid KBSN702MPA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
1. Install the Small Items Bin in top spot of door and push down to secure. To remove and replace the small items bin: 1. Remove bin by lifting it up and pulling it out. 2. Replace bin by sliding it in above the desired support and pushing down until it stops. 3. Reach under the tray with both hands and lift gently upward until front of shelf is free. Tilt the shelf at an angle and remove the shelf from the refrigerator. 4. Tilt the shelf at an angle and position it above the support rails. 5. Place shelf gently on support rails on side wall. 3. Install the Small Items Bin in the top spot of the door. Shallow Door Bins To remove and replace the shallow door bin: 1. Remove bin by lifting up and pulling out. 2. Replace bin by sliding in above the desired support and pushing down until it stops. Gallon Door Bin NOTE: The bin can only be placed on the lower door support. 1. Install bin above lowest door support adjustment slot and push down to secure. To remove and replace the gallon door bin: 1. Remove the bin by lifting and pulling out. 2. Replace the bin by sliding in above the desired support and pushing down until it stops. Marinating Pan To remove and replace Marinating Pan: 1. Remove the marinating pan by lifting it up off the brackets. Press the right-hand side of the pan inward until it is free of its bracket. Lower the right-hand side slightly and disengage the left-hand side from its bracket. 2. Replace the marinating pan by inserting the left-hand side into its bracket. Press inward on the right-hand side until it will slide past the bracket edge and set it into its bracket. NOTE: Remove everything that is below (pans/bucket) and above the Marinating Pan before removing it. For 36" For 42" Shelves and Shelf Frames To remove and replace a shelf/frame: 1. Remove the shelf/frame by tilting it up at the front and lifting it out of the shelf supports. Pull shelf straight out. 2. Replace the shelf/frame by guiding the rear shelf hooks in to the shelf supports. Tilt the front of the shelf up until the rear shelf hooks drop into the shelf supports. 3. Lower the front of the shelf and check that the shelf is in position. For 48" To purchase additional bakeware please visit: https://www.kitchenaid.com/kitchenware/bakeware.html Remove and Replace the Top Drawer Cover 1. Remove food from Top drawer cover. Pull drawer out about 4" (10.16 cm). Reach under the glass shelf with both hands and lift gently upward until back of shelf is free. Tilt the shelf at an angle and remove the shelf from the refrigerator. Be sure not to bump the glass. Pull Out Tray Remove and Replace: 1. Remove food from tray. 2. Pull drawer out about 4" (10.16 cm). 2. Replace the cover by holding the glass shelf firmly with both hands, tilt the shelf at an angle and position it above the support rails. Place shelf gently on support rails on side wall. 6