KitchenAid KBSN708MPA Owners Manual - Page 9
Electrical Requirements, Water Supply Requirements, Electrical Shock Hazard
View all KitchenAid KBSN708MPA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
� The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the plumbing for the water line can come through the floor. See "Water Supply Requirements" for more information. Electrical Requirements WARNING C Model 36 42 48 Width A (as shown above) 351/2" to 353/4" (90.2 cm to 90.8 cm) 411/2" to 413/4" (105.4 cm to 106.1 cm) 471/2" to 473/4" (120.7 cm to 121.3 cm) Dimension B (as shown above) 4" (10.2 cm) 71/2" (19.1 cm) 131/2" (34.3 cm) NOTE: Flooring under appliance must be at same level as the room Face of cabinetry must be plumbed. Installation Type Depth C (as shown above) Standard Flush (new installation) 25" (63.5 cm) minimum Retrofit Installations 24" (60.9 cm) minimum NOTE: On retrofit installations, door panels will not be flush with adjacent cabinets. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person. Do not use a cord that shows cracks or abrasion damage along its length or at either the plug or connector end. Recommended Grounding Method A 115 V, 60 Hz AC only 15 A or 20 A fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator and approved accessories be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. IMPORTANT: If this product is connected to a GFCI (Ground Fault Circuit Interrupter) protected outlet, nuisance tripping of the power supply may occur, resulting in loss of cooling. Food quality and flavor may be affected. If nuisance tripping has occurred, and if the condition of the food appears poor, dispose of the food. NOTE: Before performing any type of installation or cleaning, remove the top grille and turn the master power switch to OFF or disconnect power at the circuit breaker box. When you are finished, turn ON the master power switch or reconnect power at the circuit breaker box. Then reset the control to the desired setting. Water Supply Requirements IMPORTANT: � All installations must meet local plumbing code requirements. � Connect to potable water supply only . � There is not enough clearance to achieve a flush installation if a water shutoff valve is located in the wall behind the refrigerator. � The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. The right-hand side is recommended. The access hole through the cabinet must be within 1/2" (1.3 cm) of the rear 9