KitchenAid KCGC558JSS Installation Instructions - Page 11
Install Griddle Tray
![]() |
View all KitchenAid KCGC558JSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
You will need to determine the fittings required depending on your installation. 4. Place cooktop into the countertop cutout. NOTE: Check that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Typical flexible connection 1. Apply pipe-joint compound made for use with Propane gas to the smaller thread ends of the flexible connector adapters (see B and F in the following illustration). 2. Attach one adapter to the gas pressure regulator and the other adapter to the gas shut-off valve. Tighten both adapters. 3. Use a 15/16" (2.4 cm) combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked. A B C H D EF G A. Gas pressure regulator B. Use pipe-joint compound. C. Adapter - must have 1/2" (1.3 cm) male pipe thread D. Flexible connector E. Adapter F. Use pipe-joint compound. G. 1/2" (1.3 cm) or 3/4" (1.9 cm) gas pipe H. Manual gas shut-off valve 4. Plug into a grounded 3 prong outlet. 5. Check the operation of the surface burners. See "Check Operation of Cooktop Burners" section in the "Complete Installation" section. 6. If your model has a griddle, see the "Install Griddle Tray" section. Install Griddle Tray (On griddle models) The griddle is factory installed. 1. Place drip tray in the well at the front of the griddle. Slide tray toward the back until it stops. A Complete Connection 1. Open the manual shut-off valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. A B A. Closed valve B. Open valve 2. Test all connections by brushing on an approved noncorrosive leak-detection solution. If bubbles appear, a leak is indicated. Correct any leak found. 3. Remove cooktop burner caps, and grates from parts package. Place burner caps on burner bases. Place grates over burners and caps. B A. Griddle drip tray B. Griddle 2. Clean griddle before using. Refer to the Use and Care Guide. 11
![](/manual_guide/products/kitchenaid-kcgc506jss-installation-instructions-ceeb4d1/11.png)