KitchenAid KCGC558JSS Installation Instructions - Page 5

Parts Supplied Check that all parts are included. ■ Burner grates ■ Burner caps ■ Griddle drip tray (on griddle models) Parts Needed ■ All models must be installed with a backguard if installing at zero clearance to a combustible back wall surface such as drywall. See "Cabinet Dimensions" in the "Location Requirements" section for installation requirements. Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See the "Electrical Requirements" and "Gas Supply Requirements" sections. It is recommended that all electrical connections be made by a licensed, qualified electrical installer. Location Requirements IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. ■ It is the installer's responsibility to comply with installation clearances specified on the model/serial/rating plate. The model/serial/rating plate is located under the console on the right-hand side. ■ It is recommended that a 585 CFM (993.9 m3/hr) or larger range hood be installed above the cooktop. ■ Follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. ■ Recessed installations must provide complete enclosure of the sides and rear of the cooktop. ■ All openings in the wall or floor where cooktop is to be installed must be sealed. ■ Do not seal the cooktop to the side cabinets. ■ Cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances. ■ Grounded electrical supply is required. See the "Electrical Requirements" section. ■ Proper gas supply connection must be available. See the "Gas Supply Requirements" section. IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate, or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C). Mobile Home - Additional Installation Requirements The installation of this cooktop must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. In Canada, the installation of this cooktop must conform with the current standards CAN/CSA-A240-latest edition or with local codes. Product Dimensions NOTE: Cooktop features may differ. 30" (76.2 cm) models C B A D A. 277/8" (70.8 cm) B. 293/4" (75.6 cm) Side View of Cooktop C. 3 prong grounding-type power supply cord D. Model/serial/rating plate (located on the underside of the cooktop burner base) A B C D G A. 293/8" (74.6 cm) B. 11/4" (3.2 cm) C. Island trim or optional backguard D. 77/16" (18.8 cm) F E E. Gas inlet is located 17/8" (4.8 cm) from the back of the cooktop burner base and 47/8" (12.4 cm) in from left-hand side of the cooktop burner base. F. 22" (55.9 cm) G. 35/8" (9.2 cm) 5