KitchenAid KDRP467KSS Installation Instructions - Page 7
Gas conversions - no lights in display
View all KitchenAid KDRP467KSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3 front screws (4 rear screws required but not shown) 12. Open manual shutoff valve in gas supply line. Wait a few minutes for gas to move through the line. attaching the backguard 13. Use a brush and liquid detergent to test all gas connections. Bubbles around connections will indicate a leak. If a leak appears, shut off gas valve controls and tighten connections. Then check connections again. Never test for gas leaks with a match or other flame. Clean all detergent from range. attaching the island trim center hole not used 9. Attach the backguard or island trim as required for your installation. Attachment screws are in the literature package. 10. Slide range completely back so anti-tip bracket is over rear brace of range. regulator use pipe-joint compound flexible connector manual gas shutoff valve 1/2" flare union adapter 1/2" to 3/4" gas pipe a 1/2" male pipe thread is needed for connection to pressure regulator female pipe threads 11. Make gas connection. Assemble flexible connector from gas supply pipe to pressure regulator located in the middle front of the range. Apply pipe-joint compound made for use with L.P. gas to the smaller thread ends of the flexible connector adapters. Attach one adapter to the pressure regulator elbow and the other adapter to the gas shutoff valve. Tighten both adapters. 14. Remove cooktop burner caps, grates, and simmer plate from the parts package. Align the indentation in the burner cap with the pins on the burner base. Burner caps should be level when properly positioned. 15. Turn on power supply. "PF" should appear in the clock display. (Refer to your Use and Care Guide for instructions on using the electronic control.) 16. Check OFF operation of cooktop LITE burners. Push in and turn each control knob to the "LITE" position. The flame should light within 4 seconds. The first time a burner is lighted it may take longer than 4 seconds to light because of air in the gas line. 17. If burners do not light properly, turn cooktop control knob to the "OFF" position. Check that power supply conduit is properly wired and that circuit breaker or fuse has not blown. Check that gas shutoff valves are set to the "OPEN" position. Repeat Step 16. If a burner still does not light, contact your KitchenAid dealer or designated service company. 18. Adjust height of top burner flames. The cooktop LOW burner flame should be a steady blue flame approximately 1/4" (0.64 cm) high. It can be adjusted using the adjustment screw in the center of the valve stem. The valve stem is located directly underneath the control knob. If the LOW flame needs to be adjusted: a. Remove the control knob. b. Hold control knob stem control knob with a pair of stem pliers. Use a small flat-head screwdriver to turn screw located in the center of control knob stem until flame is the proper size. c. Replace control knob. d. Test the flame by turning the control from "LO" to "HI", checking flame at each setting. Gas conversions Gas conversions (from Natural gas to L.P. gas or from L.P. gas to Natural gas) must be done by a qualified installer. L.P. gas conversion No attempt shall be made to convert the range from the gas specified on the model/serial rating plate for use with a different gas without consulting the servicing gas supplier. An L.P. Gas Conversion Kit is included in your literature package. 7