KitchenAid KDRS407VSD Installation Instructions - Page 12
Installation Instructions
View all KitchenAid KDRS407VSD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INSTALLATION INSTRUCTIONS Unpack the Range WARNING b. Lay kick plate to the side to avoid scratching the stainless steel. c. Remove screws from range. Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. 1. Remove shipping materials, tape, and film from range. Keep shipping pallet under range. Remove oven racks, grates, and parts package from inside oven. 2. Remove kick plate. Your range will either have the kick plate already installed (follow Option 1) or packaged on top of the unit (follow Option 2). Option 1 a. Remove foam between door and kick plate. b. Remove screws from kick plate. B A. Remove these screws. 3. For 48" (121.9 cm) models only, rotate center support counterclockwise off the pallet until it stops. A A. Kick plate B. Remove these screws. c. Lift up on kick plate to release plate from shoulder screws. d. Lay kick plate to the side to avoid scratching the stainless steel. Option 2 a. Remove kick plate from top of range and grate pack. A NOTE: This support is used only for shipping and is not needed for installation. 4. Lay a piece of cardboard from side packing on the floor behind range. Using 2 or more people, firmly grasp each side of range. Lift range up about 3" (8.0 cm) and move it back until range is off shipping pallet. Set range on cardboard to avoid damaging floor. A. Kick plate In packaging A A. Kick plate Packaging removed 12