KitchenAid KDRS407VSD Installation Instructions - Page 20
Check Operation of Cooktop Burners, If burners do not light properly, Flame Height, To Adjust Flame
![]() |
View all KitchenAid KDRS407VSD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Check Operation of Cooktop Burners Push in and turn each control knob to LITE. NOTE: You will hear a clicking sound while the line clears. The surface burners and grill flames should light within 4 seconds. The first time a burner is lit, it may take longer than 4 seconds to light because of air in the gas line. After verifying the proper burner operation, turn the control knobs to OFF. If burners do not light properly: ■■ Turn cooktop control knob to OFF. ■■ Check that the range is plugged in and the circuit breaker has not tripped or the fuse has not blown. ■■ Check that the gas shut-off valves are set to the "open" position. ■■ Check that burner caps are properly positioned on burner bases. Repeat startup. If a burner does not light at this point, contact your dealer or authorized service company for assistance. Flame Height The cooktop flame should be a steady blue flame approximately ¼" (0.64 cm) high. Dual Flame Burner A B 5. Pull up on the control console, and let it drop forward into the notched console brackets on each side. A A. Control console bracket 6. Remove the round gasket from the valve stem. 7. Put a control knob onto the valve stem of the burner you want to adjust. 8. Turn the control knob to LO and using a butane extension lighter, light the burner. A. Upper (simmer) flame B. Lower flame Single Flame Burner To Adjust Flame Height: 1. Unplug range or disconnect power. 2. Remove burner grates. 3. Remove the control knobs. 4. Open the oven door and remove the 2 screws on each side of the range that hold the control console in place. 9. Remove the control knob. 10. Use a ¹⁄8" x 4¼" flat-blade screwdriver to adjust the flame height. Tighten screw to reduce flame height. Loosen screw to increase flame height. NOTE: When you are converting to LP gas, the screw should be tightened down completely on the single-output valves. The dual-output valve should not be adjusted. NOTE: Make sure to leave oven door open, or the control console will not rest in the side brackets properly once it is detached. A B A. Single flame burner adjustment screw (on right side of valve) B. Dual flame burner adjustment screw (on left side of valve) 20
![](/manual_guide/products/kitchenaid-kdrs463vbk-installation-instructions-d4ab33e/20.png)