KitchenAid KDTE204GPS Use & Care Guide - Page 5

Start-Up/Quick Reference Clean EQ Wash System removable filters to maintain peak performance Cleaning the filters periodically helps keep the dishwasher working at peak performance. The filters can be found at the bottom center of your dishwasher. See "Filtration System" section for information on removing and maintaining the filters. Drying - Rinse aid is essential You must use a drying agent such as a rinse aid for good drying performance. Rinse aid along with the Heat Dry, Extended Heat Dry, ProDry™, or Extended ProDry™ option will provide best drying and avoid excessive moisture in SLIDE dishwasher interior. Express Wash - When you need fast results Efficient dishwashers run longer to save water and energy, just as driving a car slower saves on gas. When you need fast results, the Express Wash will clean your dishes using slightly more water and energy. Select the Heat Dry or ProDry™ option to include automatic drying (adds approximately 38 to 45 minutes to the Express Wash cycle). ProWash™ cycle for optimal cleaning The most advanced and versatile cycle. ProWash™ cycle senses the soil amount and toughness of soil to adjust the cycle for optimal cleaning using only the amount of water and energy needed. The ProWash™ and Tough cycles are recommended for tough soil. No need to pre-rinse dishes; just scrape leftover food into the trash or disposal and load. Touch Start/Resume every time you add a dish IMPORTANT: If anyone opens the door (such as for adding a dish, even during the Delay option), Start/Resume must be touched each time. Push the door firmly closed within 4 seconds of touching Start/Resume. If the door is not closed within 4 seconds, the Start/Resume keypad LED will flash, an audible tone will be heard, and the cycle will be canceled. Proper Detergent Dosing High-quality premeasured tablets and packs are recommended for improved performance. It is possible to use too much detergent in your dishwasher. This can lead to etching of your dishes. See "Add Detergent" and "Add Rinse Aid" in the "Dishwasher Use" section, to determine the amount of detergent needed based on your water hardness. Quick Steps 1 Remove bulk food and load dishwasher. Scrape off excess food into garbage or food disposer. Load dishes so that water spray will reach every surface. 2 Add detergent and rinse aid. SLIDE SLIDE 3 Select a cycle and options (varies by model). 4 Start the dishwasher. To start and resume a cycle, press START/RESUME and close the door within 4 seconds. If the door is not closed within 4 seconds, the Start/ Resume LED will flash, and the cycle will not start. 5