KitchenAid KECD867XSS Installation Guide - Page 3
Installation Requirements - 36
UPC - 883049202457
View all KitchenAid KECD867XSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Grounded electrical supply is required. See "Electrical Requirements" section. ■ If cabinet has drawers, drawers will need to be removed and drawer fronts installed on front of cabinet. IMPORTANT: An under-counter built-in oven cannot be installed under this product. ■ Tape measure ■ Flat-blade screwdriver ■ Phillips head screwdriver ■ Drill ■ Level ■ 6" socket extension ■ Marker or pencil ■ Pliers ■ ¼" drill bit ■ Jigsaw ■ Ratchet with ³⁄₈"socket Product Dimensions 30" (76.2 cm) Cooktop - for standard and electric models Parts supplied ■ Vent grille ■ Pre-filter Parts needed ■ A UL listed or CSA approved strain relief for 2.2 cm) knockout. ■ A UL listed or CSA approved conduit connector for ¹⁄₂" (1.3 cm) trade-size metal-clad conduit ■ UL listed wire connectors ■ Metal ducting ■ Wall cap 6" (15.2 cm) Round Surface Wall Cap Damper Order Part Number A406 5" (12.7 cm) Round Surface Wall Cap Damper Order Part Number A405 3¼" x 10" (8.3 x 25.4 cm) Surface Wall Cap Damper Order Part Number A403 To order, see the "Assistance or Service" section of the Use and Care Guide. ■ Vent clamps Check local codes. Check existing electrical supply. See "Electrical Requirements" section. It is recommended that all electrical connections be made by a licensed, qualified electrical installer. Location Requirements IMPORTANT: Observe all governing codes and ordinances. When installing cooktop, use minimum dimensions given. ■ To eliminate the risk of burns or fire by reaching over the heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets. ■ Use the countertop opening dimensions that are given with these Installation Instructions. Given dimensions are minimum clearances and provide 0" (0 cm) clearance. B C A A. Model/serial rating/clearance plate location B. 21" (53.4 cm) screw head to screw head C. 22" (52.3 cm) without stainless steel trim or 21 54.8 cm) with stainless steel trim A B C D E F H G I A. 30 76.3 cm) with stainless steel trim B. 29 76.1 cm) without stainless steel trim C. 14 36.4 cm) D. 3 10.1 cm) E. 18 46.8 cm) F. 1 3.4 cm) G. 13 33.3 cm) H. 14 36.0 cm) I. 28⁵⁄₈" (72.7 cm) screw head to screw head 3