KitchenAid KGRS205TWH Installation Instructions - Page 14

3. Turn the Number M50 Natural gas broil burner orifice hood counterclockwise to remove. 3. Using a Phillips screwdriver, remove the burner base. A C B D M50 A A. Number M50 Natural gas broil burner orifice hood 4. Install the Number 57 LP gas broil burner orifice hood, turning it clockwise 4 or 5 turns. Do not overtighten. 57 A A. Burner cap B. Gas tube opening C. Burner base screws D. Burner base 4. Apply masking tape to the end of a 7.0 mm) nut driver to help hold the Natural gas orifice spud in the nut driver while changing it. Press nut driver down onto the Natural gas orifice spud and remove by turning it counterclockwise and lifting out. Set the Natural gas orifice spud aside. A A. Number 57 LP gas broil burner orifice hood 5. Place the broil burner on the broil burner orifice hood. Insert the broil burner locator pin in the hole in the oven back. 6. Position the broil burner against the roof of the oven cavity and attach with screw. AB C D A. Broil burner orifice hood B. Broil burner C. Broil burner locator pin D. Broil burner locator hole To Convert Surface Burners 1. If installed, remove the burner grates. 2. Remove the burner caps. 14 A. Natural gas orifice spud Use the following chart for correct LP gas orifice spud for each burner. Refer to the rating plate on the lower right side of the front frame for proper sizing of LP gas orifice spuds for each burner location. LP Gas Orifice Spud Chart Burner Rating Color Number 4,000 BTU Blue 64L 9,100 BTU Clear 91L 10,500 BTU Green 97L 14,000 BTU Red 114L 5. Replace the Natural gas orifice spud with the correct LP gas orifice spud. See the "LP Gas Orifice Spud/Hood Chart." 6. Replace burner base and hand tighten the screws. 7. Replace burner cap. 8. Repeat steps 1 through 7 for the remaining burners. 9. Place Natural gas orifice spuds in plastic parts bag for future use and keep with package containing literature. 10. Replace burner grates. 11. Reinstall storage drawer. See the "Replace Oven Racks and Storage Drawer" section for instructions. 12. Reinstall oven door. See the "Oven Door" section in the Use and Care Guide. 13. Complete installation. See "Make Gas Connection" and "Electronic Ignition System" sections. Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" to ½" long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip. IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner.