KitchenAid KUDE60FXSS Installation Guide - Page 13

WARNING 4 Power Cord−Secure cord on strain relief Electrical Shock Hazard Electrically ground dishwasher. Connect ground wire to green ground connector in terminal box. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 2 Power Supply Cord- Connect ground wire Tighten strain relief screws to secure cord. 5 Power Cord-Reinstall terminal box cover Ground wire Ground wire Washer Ground connector Remove the green grounding screw and place through the ring terminal of the green ground wire. Reattach and tighten the green screw. 3 Power Cord-Connect remaining wires Place wires inside terminal box. Insert tabs on left side of cover. Make sure wires are tucked inside box. Close cover ensuring wires are not pinched. Use ¹⁄₄" nut driver and previously removed screw to secure cover. NOTE: Do not plug into outlet until instructed to do so. Determine Cabinet Opening 1 Measure cabinet opening NOTE: Twist on wire connector. Gently tug on wires to be sure both are secured. Connect wires black to black and white to white, using UL Listed/CSA Approved twist-on wire connectors (included with power supply cord kit). Wiring configuration Power supply wire: white black ground wire Terminal box wire: white black ground connector If needed, see website for animated representation of this step. Visit www.kitchenaid.com under FAQ tab. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you will need to measure the lowest point on the underside of the countertop and the highest point on the floor). Refer to "Dishwasher Height Adjustment Chart" for wheel position and the number of turns needed. 13