KitchenAid KUDE60FXSS Installation Guide - Page 3

Installation Requirements - plastic studs

Page 3 highlights

INSTALLATION REQUIREMENTS Tools and Parts Gather the recommended tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. All Installations Tools needed: Pliers Flat-blade screwdriver Phillips screwdriver Utility knife " " nut drivers or hex sockets Measuring tape or ruler UL Listed/CSA Approved twist-on wire connectors* Small level 10" adjustable wrench that opens to " " wrench If installing custom front panels, Torx®† T15 screwdriver *Must be the proper size to connect your household wiring to 16-gauge wiring in dishwasher Other useful items you may need: Flashlight Bath towel Supplied in Kit: 4 Plastic studs (attached to each other by runners) 4 Short screws (10-16 hex head screw) 4 Long screws (8-18 Torx®† head screws) 1 Template (located inside Use and Care Guide bag assembly) 1 Instruction sheet (located inside Use and Care Guide bag assembly) NOTE: The screws supplied are used for only ³⁄₄" thick wooden panel. If the wooden panel is less than ³⁄₄" thick, customer must purchase screws locally. Other parts you may also need: (3.81-5 cm) Screw-type clamps (3 maximum) Masking or Moisture duct tape barrier tape (Part Number 4396277). NOTE: Moisture barrier tape is recommended when installing a dishwasher under a wood countertop. NOTE: Parts available for purchase in plumbing supply stores. Check local codes. Check existing electrical supply. See "Electrical Requirements" section. It is recommended that electrical connections be made by a licensed electrical installer. In addition, for first-time installations Tools needed: Cordless drill with and 1¹⁄₂" hole saw bits Small tubing cutter Wire stripper Shallow pan Wood block Parts supplied: Drain hose Drain hose 2 - under- 2 - clamps (2) Phillips- counter custom (1 large and head mounting tape 1 small) screws (2) brackets (top) Parts needed: Copp O.D. suggested) or flexible braided water supply line See "Electrical Requirements" section. For Direct Wire: use UL Listed/ CSA Approved strain relief hole For Power Supply Cord: use UL Listed/CSA Approved power supply cord kit marked for use with dishwasher MSailkveersuGrreeaelnl these parts are included in the literature package. Parts needed: Additional parts supplied with top-venting models only: " Torx® T15 screws " 4 #10 x ¹⁄₂" wood screws (if installing custom front panels) †® TORX is a registered trademark of Saturn Fasteners, Inc. Additional parts supplied with certain models only: Bottom sound pad (located in lower rack) Make sure all these parts are included in the literature package. If parts are not included, call 1-800-422-1230. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

Tools and Parts
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
All Installations
Tools needed:
*Must be the proper size to connect your household wiring
to 16-gauge wiring in dishwasher
Other useful items you may need:
Parts supplied:
Parts needed:
4 #10 x
¹⁄₂
" wood screws (if installing custom front panels)
Wire stripper
Small
tubing cutter
Cordless drill
with
¹⁄₂
",
³⁄₄
"
and 1
¹⁄₂
" hole
saw bits
Pliers
UL Listed/CSA
Approved twist-on
wire connectors*
wrench
Small level
Utility knife
Phillips
screwdriver
Measuring tape
or ruler
10" adjustable wrench
that opens to
Flat-blade
screwdriver
nut drivers or
hex sockets
If installing custom front panels,
Torx
®†
T15 screwdriver
"
"
"
"
INSTALLATION REQUIREMENTS
Copp
O.D. suggested) or
flexible braided
water supply line
For Direct Wire:
use UL Listed/
CSA Approved
strain relief
hole
See
Electrical Requirements
section.
For Power Supply
Cord: use UL
Listed/CSA
Approved power
supply cord kit
marked for use with
dishwasher
Flashlight
Bath towel
Wood block
Shallow pan
3
Masking or
duct tape
(3.81
5 cm)
Screw-type
clamps (3 maximum)
Moisture
barrier tape
(Part Number
4396277).
Torx
®
T15 screws
"
"
Bottom sound pad
(located in lower rack)
Supplied in Kit:
4 Plastic studs (attached to each other by runners)
4 Short screws (10-16 hex head screw)
4 Long screws (8-18 Torx
®†
head screws)
1 Template (located inside Use and Care Guide bag
assembly)
1 Instruction sheet (located inside Use and Care Guide bag
assembly)
NOTE:
The screws supplied are used for only
³⁄₄
" thick
wooden panel. If the wooden panel is less than
³⁄₄
" thick,
customer must purchase screws locally.
Other parts you may also need:
NOTE:
Moisture barrier tape is recommended when installing a
dishwasher under a wood countertop.
NOTE:
Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
Electrical Requirements
section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Tools needed:
Parts needed:
Additional parts supplied with top-venting models only:
Additional parts supplied with certain models only:
Make sure all these parts are included in the literature package.
If parts are not included, call 1-800-422-1230.
†®
TORX is a registered trademark of Saturn Fasteners, Inc.
Drain hose
Drain hose
clamps (2)
(1 large and
1 small)
Phillips-
head
screws (2)
Green
Silver
2
under-
counter
mounting
brackets (top)
2
custom
tape