KitchenAid KUID508HPS Installation Instructions - Page 11

14. Attach 1/2" I.D. x 10 ft (3 m) drain tube to pump discharge tube. See "Parts Locations" illustration. NOTE: Do not connect outlet end of drain tube to a closed pipe system to keep drain water from backing up into the ice maker. For standard model, skip to step 17. 15. Install the cable tie on the rear panel using two holes provided on the rear panel. Connecting the Water Line 1. Turn off main water supply. Turn on nearest faucet long enough to clear line of water. 2. Using a 1/2" copper supply line with a quarter-turn shutoff valve or the equivalent, connect the ice maker as shown. NOTE: To allow sufficient water flow to the ice maker a minimum 1/2" diameter home supply line is recommended. A A B A. Holes to fix the cable tie 16. Using a cable tie, fix the drain tube to rear panel. 17. For standard model, place new rear panel (small one for 15" ice makers, large one for 18") against the back of the ice maker. For custom panel model, reuse the plastic rear panel (removed in step 2). Route the vent tube and drain pump discharge tube through cutouts in the rear panel. 18. Secure rear panel with original screws. See "Rear Panel" illustration. 19. Check all connections for leaks. Connect Water Supply Read all directions before you begin. IMPORTANT: ■■ Connect to potable water only. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. ■■ Plumbing shall be installed in accordance with the International Plumbing Code and any local codes and ordinances. ■■ Use copper tubing or Whirlpool supply line, Part Number 8212547RP, and check for leaks. ■■ Install tubing only in areas where temperatures will remain above freezing. Tools Needed: Gather the required tools and parts before starting installation: ■■ 7/16" and 1/2" open-end wrenches or two adjustable wrenches NOTE: Do not use a piercing-type or 3/16" (4.76 mm) saddle valve which reduces water flow and clogs more easily. A. Bulb B. Nut 3. Now you are ready to connect the copper tubing. Use 1/4" (6.35 mm) O.D. soft copper tubing for the cold water supply. ■■ Ensure that you have the proper length needed for the job. Be sure both ends of the copper tubing are cut square. ■■ Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten. ■■ For custom panel install, be sure there water line extends 30" beyond the cabinet for future servicing purpose A B C A. Compression sleeve B. Compression nut C. Copper tubing 4. Place the free end of the tubing into a container or sink, and turn on main water supply and flush out tubing until water is clear. Turn off shutoff valve on the water pipe. IMPORTANT: Always drain the water line before making the final connection to the inlet of the water valve to avoid possible water valve malfunction. 11