KitchenAid KUID508HPS Installation Instructions - Page 8
Drain Pump Installation (on some models), Reverse Door Catch
View all KitchenAid KUID508HPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Screw the two hex heads screws back in at the bottom of the door. For custom door panel, skip this step. WARNING 6. Return the ice maker back to upright position. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Reverse Door Catch 1. Remove the white decorative screws from the opposite side of the door and set aside. 2. Remove the screws from the magnetic door catch and place them on the opposite side of the door. 3. Install the white decorative screws on the opposite side of the door. 4. Plug into a grounded 3 prong outlet. Drain Pump Installation (on some models) NOTES: ■■ Connect drain pump to your drain in accordance with all state and local codes and ordinances. ■■ It may be desirable to insulate drain tube thoroughly up to drain inlet to minimize condensation on the drain tube. Insulated tube kit Part Number W10365792 is available for purchase. ■■ Drain pump is designed to pump water to a maximum height of 10 ft (3 m). Use only Whirlpool approved drain pump kit Part Number 1901A. ■■ Do not connect the outlet end of the drain tube to a closed pipe system to keep drain water from backing up into the ice maker. Kit Contains: ■■ Drain pump kit Part Number 1901A ■■ 5/8" I.D. x 51/8" drain tube (ice maker bin to drain pump reservoir inlet) ■■ 1/2" I.D. x 10 ft (3 m) drain tube hose (drain pump discharge to household drain) ■■ 5/16" I.D. x 32" (81 cm) vent tube (drain pump reservoir vent to ice maker cabinet back) ■■ Cable tie (secures vent tube to back of ice maker) (1) ■■ #8-32 x 3/8" pump mounting screws (secures drain pump to baseplate and clamps to back of ice maker) (5) ■■ 5/8" small adjustable hose clamp (secures vent to drain pump) ■■ 7/8" large adjustable hose clamp, (secures drain tube to ice maker bin and drain pump reservoir inlet) (3) ■■ Rear panel (2) ■■ Instruction sheet 8