Kodak 8342693 User Guide - Page 179

Imprinting You can install an optional document printer in the Scanner 1500 and Scanner 2500. The Scanner 1500 supports a front document printer, while the Scanner 2500 supports both front and rear document printers. While you can install a document printer in both the front and rear of the Scanner 2500, only front or rear imprinting can be enabled at any one time. None-imprinting is disabled. Front-the front document printer prints on the front side of the document before scanning. Therefore, the scanned image will include the imprinted data. Rear-the rear document printer prints on the back side of the document after scanning. Therefore, the scanned image will not include the imprinted data. When imprinting is enabled, you must specify the Start position and the Text to be imprinted. The Start position indicates how far down vertically on the page imprinting will begin. The start position is specified the units of 2.4 mm. Imprinting cannot be done on the first or last 10 mm on a scanned page. Therefore, a Start position of "0" causes imprinting to begin 10 mm down from the top of the paper. Furthermore, a Start position of 10 (20.4 mm) causes imprinting to begin 30.4 mm (approximately 1.2 in.) from the leading edge of the page. The horizontal position across the page must be set on the document printer unit inside the scanner. You cannot specify the horizontal position within Capture Software. Specify the data to be imprinted in the Text box. You can either type in the information you want to be imprinted or you can press the Setup button to access the Imprinter Text Setup dialog box to build an imprinter text formula based on pre-defined values. The left side of the dialog box contains a list of pre-defined values that you can use to build the imprinter text formula. The imprinter text can consist of one or more pre-defined values as specified in the formula. 4-6 A-63054 February 2004