Kodak 861 2459 User Guide - Page 75
Problem solving, Problem, Possible Solution
UPC - 041778612453
View all Kodak 861 2459 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Problem solving Use the chart below as a guide to check possible solutions to problems you may encounter when using the Kodak i30/i40 Scanner. Problem Possible Solution Scanner will not scan/feed documents Make sure that: • the power cord is plugged securely into the back of scanner and the wall outlet. • the power supply, green LED is lit. • the power switch is on. • the wall outlet is not defective (call a licensed electrician). • the PC was restarted after installing the software. • document(s) is making contact with the feed rollers. • if you are feeding a small document, be sure that the document passes over the left-edge sensor. Image quality is poor or has decreased • Clean the scanner. See the procedures in Chapter 5, Maintenance. Documents are jamming or multiple documents are feeding Make sure that: • the input tray and side guides are adjusted for the width of the documents you are scanning. • the output tray is adjusted for the length of the documents you are scanning. • all documents meet the specifications for size, weight and type as outlined in the section entitled, "Document preparation". • the scanner is clean. • the feed module is installed properly and securely in place. • if you are feeding a small document, be sure that the document passes over the left-edge sensor. Distorted images The feeder holds up to 50 documents in the input tray. While scanning is taking place, you cannot add documents to the feeder. If you do add documents, your images may be distorted. Scanning multiple pages in "Single Page mode" • When scanning multiple pages using Single Page mode, the scanner will pre-feed the next document and the last document scanned will stay in the transport until the next page is scanned. This is a normal scanner process. The document that remains in the transport can be safely pulled out if you want, however, it will automatically be completely fed through the transport and into the output tray when the next page or last page is scanned. No images are being displayed • Documents should only be inserted in the feeder after the scanner is powered up and ready. If you place documents in the input tray before the scanner is powered up, the documents will be feed, but no images will be displayed. • If you are scanning one side of a document, or if you have a Kodak i30 Scanner, be sure the side you want to scan is placed toward the feed tray (not facing you). For more information, see the section entitled, "Scanning your documents" in Chapter 3. Image has clipped corners If your images have clipped corners, the skew angle was too large for the scanner to handle. Be sure documents are placed in the input tray with the edges aligned and the side guides positioned correctly to accommodate the size documents you are feeding to avoid large skew angles. 72 A-61512 May 2006