Konica Minolta DR1600 DR1600/DAR2800 Operator Manual - Page 16

4 Select the thickness of film loaded using the Film Thickness Select Switch, either 2.5 mil or 5 mil. -LkI2LE] If a wrong setting is made, the Film Supply Indicator and alarm will function incorrectly. 25 5 a CID 5 Install the Film Unit to the Film Unit Mounting Board and turn ON the DR1600/DAR2800 with the Power ON/OFF Switch. Advance the film about 100 frames using the Spacing Key. - NOTES' • Make sure that the Film Unit Release Lever is placed in the "SET" position. • Observing the Film Movement Indicator, check that the film is threading properly. If film is not threading properly, rethread it by following the instructions. 2. Unloading Film The Film Empty Indicator blinks red with beeps sounding as the length of film still available for exposure reaches a given point during microfilming. (approx 1.5 meters or 5 feet). When this occurs stop filming and change film roll, immediately unload the exposed film from the Film Unit. An exposed portion of film can also be easily unloaded before the entire roll of film is used. In either case, make sure that the exposed film is placed in a light-proof container immediately after removal. u Unloading Partial Roll: 71 a (lb 1 After the last exposure has been taken, hold down the Spacing Key until the Film Unit advances film about 100 frames. Turn Power ON/OFF Switch off, place the Film Unit Release Lever in the left (RELEASE) position, then lift the Film Unit straight up and remove it from the DR1600/DAR2800. 13