Konica Minolta Kodak i1320 Plus User Guide - Page 35

Adjusting the pre-separation roller tension

Get Konica Minolta Kodak i1320 Plus PDF manuals and user guides View all Konica Minolta Kodak i1320 Plus manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

6. Replace the core assembly in the feed module. You may need to slide the shaft to the right or left so the core fits properly within the feed module housing. Adjusting the preseparation roller tension 7. Repeat the replacement procedure outlined above for the other core assembly. 8. Reinstall the feed module. 9. Reinstall the feed module cover by aligning the tabs in the slots and pushing the feed module cover down until it snaps into place. If you are experiencing multi-feeds or document jams, it may be necessary to adjust the pre-separation roller tension. 1. Remove the separation module from the scanner by following the steps described previously in "Replacing the separation module and tires". 2. Locate the spring on the separation module. 3. Lift the spring from the holder and move it to the left or right as desired to adjust the tension. A-61560 January 2010 4-13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
A-61560
January 2010
4-13
6.
Replace the core assembly in the feed module. You may need to
slide the shaft to the right or left so the core fits properly within the
feed module housing.
7.
Repeat the replacement procedure outlined above for the other core
assembly.
8.
Reinstall the feed module.
9.
Reinstall the feed module cover by aligning the tabs in the slots and
pushing the feed module cover down until it snaps into place.
Adjusting the pre-
separation roller
tension
If you are experiencing multi-feeds or document jams, it may be
necessary to adjust the pre-separation roller tension.
1.
Remove the separation module from the scanner by following the
steps described previously in “Replacing the separation module and
tires”.
2.
Locate the spring on the separation module.
3.
Lift the spring from the holder and move it to the left or right as
desired to adjust the tension.