Konica Minolta bizhub 363 bizhub 423/363/283/223 Network Scan/Fax/Network Fax - Page 292
Error messages displayed
View all Konica Minolta bizhub 363 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 292 highlights
12.3 Error messages displayed 12 12.3 Error messages displayed If the machine encounters a problem, an error dialog will appear and display one of the following error messages. Take corrective actions by referring to the table below. If a communication error persists, please contact your service representative. 12.3.1 G3 Fax Error Message [Failed to complete the job due to an error while dialing.] [Unable to check sender.] [Not enough memory to continue scanning.] [Transmission failed. Please check line connection.] [Cannot connect to the network.] [The address for the communication method cannot be selected since the number of addresses has exceeded the maximum allowed for broadcasting.] [Document could not be saved in the User Box due to insufficient HDD capacity. Check log.] [Not enough memory to continue the job. Touch [Send] or [Delete].] [The number of registered user boxes has reached the maximum allowed.] [This user box has reached its maximum number of pages allowed.] [The maximum number of jobs has been queued. Wait until a queued job is completed.] Corrective Actions Redial was attempted the number of times specified, however, transmission failed because the recipient was busy or due to other reasons. Check the recipient's state to resend the fax. The machine failed to verify the recipient with Check Dest. & Send set to [Yes]. Check that the receiver's fax number is registered correctly. During scanning of original, the memory became full. Press Start to send scanned originals. Press Stop to stop faxing. The telephone cord may have become unplugged. Check the telephone cord for connection and, if unplugged, plug it securely. Make sure that the network cable is correctly connected. In addition, make sure that [Network Settings] in Administrator Settings is correctly configured. The number of destinations specified exceeds the number possible for a broadcast transmission. Reduce the number of broadcast destinations, or send the transmission in multiple batches. The hard disk is full. Delete unnecessary data, and then try saving the data again. The memory is full. Delete unnecessary data, and then try saving the data again. The number of User Boxes that can be registered has reached the maximum number possible. Delete unnecessary User Boxes, and then try registering new boxes again. The number of documents that can be saved in a User Box has reached the maximum number possible. Delete unnecessary documents, and then try saving the document again. The number of jobs that can be programmed has reached the maximum number possible. Wait until a job has been completed, or delete a current job. bizhub 423/363/283/223 12-6