Kyocera ECOSYS FS-1320D PRESCRIBE Commands Technical Reference Manual - Rev. 4 - Page 28
Drawing Boxes and Circles, Drawing Boxes
View all Kyocera ECOSYS FS-1320D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Chapter 2 Graphics Tutorial Figure 2. 4. Result of Draw Commands: Lines in Angles The first two lines of this command sequence initiates the PRESCRIBE mode, resets printing system defaults to permanent settings, and sets the line width to 0.01 inches. Then the MZP command on line 3 moves the cursor to a point 5 inches to the right of the left edge limit and 4 inches below the top edge limit. Next, DRPA 2, 149; on line 4 draws a line two inches long at an angle of 149 degrees. The angle is measured clockwise from the vertical axis. The subsequent DRPA commands draw additional 2-inch lines at angles that increase in increments of 72 degrees. As indicated by the CMNT (CoMmeNT) commands, angles that exceed 360 degrees are equivalent to the remainder of division of the angle by 360. Drawing Boxes and Circles PRESCRIBE provides two commands especially for drawing boxes (BOX command) and circles (CIR command). Drawing Boxes The BOX (draw box) command draws a box of a specified width and height. As with the line drawing commands, the thickness of the line used to draw the box is determined by the SPD (set pen diameter) command. The following command sequence draws a box. !R! RES; UNIT C; SPD 0.1; MZP 3, 3; BOX 3, 4; PAGE; EXIT; 2-6