Kyocera ECOSYS FS-1320D PRESCRIBE Commands Technical Reference Manual - Rev. 4 - Page 60
Image Models, Operation mode, Source image, Pattern
View all Kyocera ECOSYS FS-1320D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Chapter 2 Graphics Tutorial Figure 2. 38. Image Models Source transparency mode = 0 (transparent) Pattern transparency mode = 0 (transparent) Source transparency mode = 0 (transparent) Pattern transparency mode = 1 (opaque) Source transparency mode = 1 (opaque) Pattern transparency mode = 0 (transparent) Source transparency mode = 1 (opaque) Pattern transparency mode = 1 (opaque) PRESCRIBE establishes the printing system's imaging model with the SIMG (Set IMaGe model) command. This command uses the following format. SIMG operation-mode; operation-mode is a number from 1 to 6 that determines the image model as follows. Operation mode Source image Pattern 1 Transparent - 2 Opaque - 2-38
Chapter 2 Graphics Tutorial
2-38
Figure 2. 38.
Image Models
PRESCRIBE establishes the printing system’s imaging model with the SIMG (Set
IMaGe model) command. This command uses the following format.
SIMG
operation-mode
;
operation-mode
is a number from 1 to 6 that determines the image model as follows.
Operation mode
Source image
Pattern
1
Transparent
–
2
Opaque
–
Source transparency mode = 0 (transparent)
Pattern transparency mode = 0 (transparent)
Source transparency mode = 0 (transparent)
Pattern transparency mode = 1 (opaque)
Source transparency mode = 1 (opaque)
Pattern transparency mode = 0 (transparent)
Source transparency mode = 1 (opaque)
Pattern transparency mode = 1 (opaque)