Kyocera ECOSYS M2040dn ECOSYS M2135dn/M2635dw/M2040dn/M2040dw Operation Guide - Page 74

Installing and Setting up the Machine > Energy Saver function Energy Saver function If a certain period of time elapses after the machine is last used, the machine automatically enters sleep mode, which minimizes power consumption. If the machine is not used while in sleep mode, the power automatically turns off. NOTE If user login administration is enabled, you can only change the settings by logging in with administrator privileges. If user login administration is disabled, the user authentication screen appears. Enter a login user name and password, and select [Login]. The factory default login user name and login password are set as shown below. Model Name Login User Name Login Password ECOSYS M2135dn/ECOSYS M2635dn/ 3500 ECOSYS M2635dw 3500 ECOSYS M2040dn/ECOSYS M2540dn/ 4000 ECOSYS M2540dw 4000 Sleep To enter Sleep, select the [Energy Saver] key. Message display and all indicators on the operation panel will go out to save a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep. Energy Saver indicator If print data is received during Sleep, the machine automatically wakes up and starts printing. Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing. To resume, perform the following actions. • Select the [Energy Saver] key. Recovery time from Sleep Mode is as follows. • Within 10 seconds Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly. 2-26