Kyocera FS3820N FS-3820N/3830N Installation Guide Rev 1.1 - Page 11
Connecting the Power Cord
View all Kyocera FS3820N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
6STEP Connecting the Power Cord This section describes the procedure for connecting the power cord and various cautions. Notes on Power Supply • Install the printer near an AC wall outlet, preferably one that can be used for the printer alone. • Only use this printer with the supply voltage indicated on the serial number label attached to the printer's rear panel. • If an extension cord is used, the total length of the power cord plus extension should be 5 meters (16 feet) or less. Power Requirements Voltage Frequency Current capacity 120 V (U.S.A. and Canada), 220 to 240 V (European countries, and the Asia Pacific region), ±10 % at each voltage 60 Hz (120 V) ±2 %, 50/60 Hz (220 to 240V) ±2 % 8.0 A at 110/120 V, or 4.0 A at 220 to 240 V To Connect the Power Cord • Be sure the printer's power switch is turned off. • Only use the power cord supplied with the printer. Power Cord Connector Power Cord 1 Plug the power cord into the power cord connector on the rear of the printer. 2 Connect the other end of the power cord into a power outlet. Be sure to connect to a 3-wire grounded power strip. 9