Kyocera FS3820N FS-3820N/3830N Installation Guide Rev 1.1 - Page 28

Prolonged Non-Use and Moving the Printer ■ Prolonged Non-use If you ever leave the printer unused for a long period of time, remove the power cord from the wall outlet. We recommend you consult with your dealer about the additional actions you should take to avoid possible damages that may occur when the printer is used next time. ■ Moving the Printer When you move the printer: • Move it gently. • Keep it as level as possible, to avoid spilling toner inside the printer as shown in the figure. • The handhold on the right side of the printer doubles as the memory card slot. Be sure to remove the memory card first, if inserted, before lifting or moving the printer. • Be sure to remove all the option units such as the sorter and duplexer before moving the printer. If you need to move the printer to another location, remove the toner container, waste toner box, and developer unit. The procedure for removing these is as follows: 1 Remove the toner container and waste toner box from the printer. Put the toner container into the plastic bag in which it was supplied to prevent spilling of toner. Close the cap of the waste toner box tightly. 2 Disconnect the connector of the developer unit from the printer and while pulling the developer unit release lever, remove the developer unit from the printer (1). Close the protect cover on the developer unit (2) and put the developer unit into the supplied plastic bag (3). (1) Remove the developer unit. (2) Close the protect cover. (3) Put the developer unit. 1. Disconnect 2. Pull Protect Cover Plastic bag (supplied) Developer Unit 3 Put the printer into the box in reverse order of the unpacking procedure (Refer to STEP 1 Unpacking). Position the pad as shown in the figure, then place the toner container and waste toner box. Waste Toner Box Toner Container Pad Printer Packing Carton 26