Kyocera TASKalfa 255c Fax System (U) Operation Guide Rev-1 - Page 189
Error Messages
View all Kyocera TASKalfa 255c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
Troubleshooting > Error Messages Error Messages When an error occurs, the display may show one of the error messages listed below. These will help you identify and correct the problem. NOTE When a transmission error occurs, a sent/receipt result report is produced. Check the error code shown in the report and refer to Error Code List on page 10-6 for a description. To print the sent/ receipt result report, refer to Send Result Reports on page 8-4 and FAX RX Result Reports on page 8-6. You may also check error codes using the activity report. (Refer to Activity Report on page 8-7.) Message Machine failure. Checkpoint ― Box limit exceeded. ― Job Accounting restriction ― exceeded. Restricted by Job Accounting. ― Cannot print. The phone receiver is off the hook. Scheduled sending jobs exceeded. Is the phone (commercially available) connected to the machine off the hook? ― Corrective Action Reference Page Turn the main power switch off and on, or ― unplug the power cord and plug it in again. If the message still appears, note the error code. Turn the main power switch off and unplug the power cord. Call your service representative. • Sub Address Box capacity is used up 6-13 with document data. Press [End]. The job is canceled. Try to perform the job again after printing or deleting the data in the Sub Address Box. • The polling box is full. Press [End]. The job will be canceled. Delete documents from the polling box and then repeat the operation. The number of paper used has exceeded the limit preset by Job Accounting. No further operation is possible. Press [End]. The job is canceled. Try to perform the job again after resetting the limit for paper use. Refer to the machine's Operation Guide. Fax transmission is prohibited by Job Accounting. No further operation is possible. Press [End]. The job is canceled. Check the setting for Job Accounting. Refer to the machine's Operation Guide. Hang up the handset. ― The number of jobs has exceeded the 4-16 limit set for delayed transmission. Press [End]. The job is canceled. Wait until the delayed transmission is executed, or cancel the delayed transmission and then perform the job again. 10-4