LG 49UH5C Owners Manual - Page 73

ENGLISH_index PICTURE ID Settings •• Only applies to certain models. [PICTURE ID] is used to change the settings of a specific set (display) using a single IR receiver for multi- vision. Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each monitor is identified by a Set ID. If you AUDIO assign the [PICTURE (RGB/DVI) ID] using RS-232C OUT the remote RS-232C OUT control, RS-232C OUT only displays with matching PICTURE ID and Set ID can be RS-232C IN RS-232C IN RS-232C IN controlled remotely. REMOTE CONTROL IN 1 Assign the Set ID to the installed monitors as shown below. IR & Light Sensor RS-232C cables PICTURE ID 35 NOTE •• If PICTURE ID is set to 2, only the upper right monitor, which has a Set ID of 2, can be controlled by IR signals. •• If you press the green OFF button for PICTURE ID, the PICTURE ID for all monitors are turned off. If you then press any button on the remote control, all monitors can be controlled by IR signals regardless of Set ID. 2 Press the red ON button on the remote control to assign the PICTURE ID. 3 Assign the Set ID to the selection of your choice. •• A set with a different Set ID from the PICTURE ID cannot be controlled by IR signals.