LG CF3DAT Owners Manual - Page 30

Function Using the Screen Size Function Press the RATIO button on the remote control. 16:9 Just Scan Set By Program Aspect Ratio Cinema Zoom1 Zoom 4:3 ꔈ Settings may vary depending on the input signal. ꔈ You can also use the MENU or Q.MENU button. ꔈ Press the BACK button to exit the menu screen. 16:9 ꔦ FK A Test Pattern Function * You can adjust screen size and focus while installing the projector. Press the PATTERN button on the remote control. ꔈ You can select this function through the MENU button. Using Keystone * To prevent the screen image from becoming trapezoidal, Keystone adjusts the top and bottom width of the image if the projector is not set at a right angle to the screen. * Because the Keystone function may cause inferior screen image quality, use this function only when it is not possible to set up the projector at an optimal angle. 1. Press the KEY.S button on the remote control. Keystone ꔂ Move ꕉ Prev Top left ꔃ 2. Press the ˭
ˮ buttons to select a desired option and press the ʼ button. Top Right 3. Press the buttons to adjust the screen and press OK
ㅦ ꔈ The Keystone is adjusted -100 to 0 or 0 to 100 depending on position. ꔈ To reset to the factory defaults, perform Picture Reset. ꔈ You can select this function through the MENU button. ꔈ Press the BACK button to exit the menu screen. Bottom Left Bottom Right H 0 Reset V 0 Test Pattern Changing Projection Mode (PJT Mode) * You can flip the video up/down or left/right. 1. Press the MENU button, then go to Screen with the buttons and press OK ㅦ 2. Press the ˭
ˮ buttons to go to Projection Mode and press OK
ㅦ ꔈ Select Rear to project an image onto the back of a transparent screen purchased separately. ꔈ Select Ceiling if you installed the projector on a ceiling. ꔈ You can select this function through the MENU button. ꔈ Press the BACK button to exit the menu screen. Using the AUTO Function * AUTO provides optimized picture quality by automatically calibrating the mismatch of horizontal width and picture shake caused by clashes between the internal settings of the projector and various PC graphic signals in RGB mode. * The AUTO function is available only for RGB input. Press the AUTO button on the remote control. ꔈ If you use AUTO for video signal from a PC, you may not be able to get optimized picture quality. Therefore, use the AUTO function for still images. ꔈYou can select this function through the MENU button. 30 Auto Config.