LG DLG7188WM Service Manual - Page 10
wire direct, wire receptacle, NEMA type14-30R, wire receptacle, NEMA type10-30R, wire direct - review
View all LG DLG7188WM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Electric Dryer Only Review the following options to determine the appropriate electrical connection for your home: 4-wire receptacle (NEMA type14-30R) Use the instructions under option 1 if your home homehas a 4-wire receptacle (NEMA type 14-30R). 3-wire receptacle (NEMA type10-30R) Use the instructions under option 2 or 3 if your home has a 3-wire receptacle (NEMA type 10-30R). Use option 2 if local codes and ordinances permit the connection of a chassis ground to the neutral connector. If this is not permitted, use option 3. 5" (12.7 cm) 31/2" (8.6 cm) 1" (2.5 cm) (12.75c" m) 1" (2.5 cm) 4-wire direct 3V2" (8.9 cm) 4-wire connection : Direct wire Important : Grounding through the neutral conductor is prohibited for (1) new branch-circuit installations, (2) mobile homes, and (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductor. Prepare minimum 5ft(1.52m) of length in order for dryer to be replaced. First, peel 5 inch (12(1.27.57c"cmm)) of covering m(a8t.36e1/c2r"mia) l from end. Make a 5 inch of ground wire bared. After cutting 11/2 inch (3.8cm) from 3 other wires. peel insulation back 1inch (2.5cm). Make ends of 3 wires a hook shape. 1" (2.5 cm) (12.75c" m) ( Then, put the hooked shape end of the wire under the screw of the terminal block(hooked end facing rightward) and pinch the hook together and screw tightly. If this type is available at your home. you will be connecting to a fused disconnect or circuit breaker box 5" (12.7 cm) 3-wire direct 31/2" (8.6 cm) If this type is available at your home. you will be connecting box to a fused(21d.5"icsmc)onnect or circuit breaker (12.75c" m) 1. Connect neutral wire(white) of power cord to center terminal block screw. 2. Connect red and black wire to the left and right terminal block screws. 3. Connect ground wire(green) of power cord to external ground screw and move neutral ground wire of appliance and connect it to center screw. 4. Make sure that the strain relief screw is tightened. and be sure that all terminal block nuts are on tight and power cord is in right position. 1" (2.5 cm) D 3V2" E (8.9 cm) F a C b 9