LG DLG7188WM Service Manual - Page 11
wire connection : Direct wire, wire connection with, a Power supply cord. - installation
View all LG DLG7188WM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3-wire connection : Direct wire Important : Grounding through the neutral conductor is prohibited for (1) new branch-circuit installations, (2) mobile homes, and (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductor. Prepare minimum 5ft(1.52m) of length in order for cm) dryer to be 31/2" (8.6 cm) replaced. First, peel 3 1/2 inch (8.9cm) of covering material from end and bare 1 inch from the ends. 1" (2.5 cm) 1" (2.5 cm) (12.75c" m) 3V2" (8.9 cm) Then, put the hooked shape end of the wire under the screw of the terminal block(hooked end facing rightward) and pinch the hook together and screw tightly. Option 1: 4-wire connection with a Power supply cord. • lf your local codes or ordinances do not allow the use of a 3 wire connection, or you are installing your dryer in a mobile home, you must use a 4wire connection. 1. Connect neutral wire(white) of power cord to center terminal block screw. 2. Connect red and black wire to the left and right terminal block screws. 3. Make sure that the strain relief screw is tightened and be sure that all terminal block nuts are on tight and power cord is in right position. D E F a C b C 1. Connect the neutral wire (white) of the power B cord to the center terminal block screw. D 2. Connect the red and black wires to the left and a right terminal block screws. E 3. Connect the ground wire (green) of the power cord to the external ground screw. Remove the neutral ground wire of appliance and connect it to center screw. 4. Make sure that the strain relief screw is tightened 10 and that all terminal block nuts are tight and the power cord is in the right position.