LG GCC-4520B Owners Manual - Page 10

DirectCDTM v2.5b(s) Installation Jumper Setup Before installation, set the jumper connector on the rear panel. The drive can be connected as the Master or Slave on an EIDE (ATAPI) interface. When several (up to four) EIDE devices are connected, each must be set in a unique way. Specific knowledge of hardware and software is necessary to install the drive. NOTE : If two peripheral devices with the same settings are both connected to the Primary or to the Secondary EIDE bus, the host computer may fail to run or may malfunction. Careful attention is necessary. DIGITAL AUDIO R ANALOG AUDIO G L C S S L M A 39 40 D G INTERFACE 1 POWER +5 GND +12 2 AL O R G ANALOG AUDIO C S M L S LA CS: Cable Select (CSEL) SL: Slave MA: Master 39 40 NOTE : Only one jumper should be installed on the jumper connector. If more than one jumper is installed, the drive may malfunction or be damaged. Master/Slave setting is determined by jumper installation on the Jumper Connector. The following table shows the possible jumper settings. Name MA (Master) SL (Slave) CS (Cable Select) Function Drive set as Master Drive set as Slave Drive mode set by CSEL on the host IDE interface C S M S L A If you use CSEL setting, the MASTER/SLAVE setting will be made automatically, depending on the hardware configuration. For details refer to the manual of your computer. 7