LG H20J55DT Owner's Manual - Page 55

LT2002 Clone Programmer Clone Operation Notes Disconnect the Clone from the TV when you are finished; automatically switching it off. The realtime clock continues to run after the main circuits are switched off. Reset Clone After Static Shock After replacing exhausted batteries, or if the programmer behaves strangely after a static shock, use a paper clip or similar instrument inserted through the small hole marked "RESET" to activate the internal reset switch and restore normal operation. After a reset, check the real-time clock setting. It may be necessary to reset the Clone Programmer clock from a TV containing the correct time. The LT2002 programmer is designed to be used with TV's containing the 221-01006 and later processors. Use with earlier TV sets may give unpredictable results. The specific microprocessor used in any TV set may be determined by activating the Installer Menu. The microprocessor part number appears on the screen when the Installer Menu is activated. Processors before the 22101006-04 have a limited screen display capability. They can not display entire screens as shown in the quick setup instructions accompanying the LT2002 clone programmer. Use the printed menu illustrations on the quick setup sheet supplied with the Clone as an aid to making your programming choices. ( Although the menus are not all displayed, the clone functions all operate normally). Clone Programmer/Cloning Procedure Troubleshooting Problem Possible Cause(s) Possible Solution(s) Clone Programmer LED does not blink. • M.P.I. cord not connected. • TV not turned On. • Weak batteries. Clone menu hard to read. No time set. • Weak signal. • No time on Master TV. Menu items 7-8 not on clone selection menu. • Not necessary. - Connect M.P.I. cord. - TV must be On for clone to work. - Install 4 fresh AA high-quality alkaline batteries. - Connect TV to a reliable signal Source. - Set time on master TV, copy time to Clone Programmer. - Channel Labels already cloned; if they were on Master TV. Master and Other TV's Cloning did not work. • Procedure interrupted. • Different TV models. Clone time disappeared. • Batteries were removed. New Setup not present. • TV not reset. Digital information not present. • 2-5-5 + Menu not done. - Wait until procedure complete message is displayed. - Cloning is only possible with identical model Zenith TV's. - Batteries must remain installed to retain time settings. - Disconnect newly-cloned TV from power for 15 seconds. - Redo setup and 2-5-5 + Menu as required. When cloning operations are complete, just unplug the LT2000 from the TV. If the TV does not display a picture (blank screen) after a few seconds, just change channels. 206-4065 Page 55