LG LRG3095ST Owner's Manual - Page 47

English - f11 error code

Get LG LRG3095ST PDF manuals and user guides View all LG LRG3095ST manuals
Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

TROUBLESHOOTING ENGLISH BEFORE CALLING FOR SERVICE Problem Oven door will not open after a self-clean cycle Possible Causes • The oven temperature is too high. Solutions • Allow the oven to cool below locking temperature. • This can take up to 1 hr after the cycle is complete. Oven not clean after a self-clean cycle • Improper oven controls setting. • The oven was heavily soiled. • See the Using the "USING THE SELF-CLEANING OVEN" section. • Clean up heavy spillovers before beginning the self- clean cycle. Heavily soiled ovens may need to self-clean again or for a longer period of time. "CLOSE DOOR TO CONTINUE BROILING" or "DOOR OPENED" appears in the display • The broil or self-clean cycle has been selected but the door is not closed. • Close the oven door. "DOOR LOCKED" light is on when you want to cook • The oven door is locked because the temperature inside the oven has not dropped below the locking temperature. • Touch the "CLEAR OFF" pad. Allow the oven to cool. Oven control beeps and displays any F code error. • You have "F3". • Touch the "CLEAR OFF" pad. Allow the oven to cool for one hour. Put the oven back into operation. • You have "F11". • Check the main gas shut-off valve or the oven gas shut-off valve(see "Surface burners light but oven burner does not" column). • If the function code repeats. • Disconnect all power to the range for 5 minutes and then reconnect power. If the function error code repeats, call for service. Oven racks are difficult to slide • The oven racks were cleaned in a self-clean cycle. • Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven racks with the paper towel. Do not use lubricant sprays. Power outage, clock flashes • Power outage or surge. • Reset the clock. If the oven was in use, you must reset it by touching the "CLEAR OFF" pad, setting the clock and resetting any cooking function. "Burning" or "oily" • This is normal in a new oven and odor emitting from the will disappear in time. vent • To speed the process, set a self-clean cycle for a minimum of 3 hours. See the "USING THE SELFCLEANING OVEN" section. Strong odor • An odor from the insulation around the inside of the oven is normal for the first few times the oven is used. • This is temporary. Fan noise • The convection fan may turn on and • This is normal. The convection fan will shut off if off automatically. the door is opened. 47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
TROUBLESHOOTING
47
ENGLISH
BEFORE CALLING FOR SERVICE
Problem
Possible Causes
Solutions
Oven door will not
open after a self-clean
cycle
Oven not clean after a
self-clean cycle
“CLOSE DOOR TO
CONTINUE BROILING”
or “DOOR OPENED”
appears in the display
“DOOR LOCKED” light
is on when you want to
cook
Oven control beeps
and displays any F
code error.
Oven racks are
difficult to slide
Power outage, clock
flashes
“Burning” or “oily”
odor emitting from the
vent
Strong odor
Fan noise
• The oven temperature is too high.
• Improper oven controls setting.
• The oven was heavily soiled.
• The broil or self-clean cycle has
been selected but the door is not
closed.
• The oven door is locked because the
temperature inside the oven has not
dropped below the locking
temperature.
• You have “F3”.
• You have “F11”.
• If the function code repeats.
• The oven racks were cleaned in a
self-clean cycle.
• Power outage or surge.
• This is normal in a new oven and
will disappear in time.
• An odor from the insulation around
the inside of the oven is normal for
the first few times the oven is used.
• The convection fan may turn on and
off automatically.
• Allow the oven to cool below locking temperature.
• This can take up to 1 hr after the cycle is complete.
• See the Using the “USING THE SELF-CLEANING
OVEN” section.
• Clean up heavy spillovers before beginning the
self- clean cycle. Heavily soiled ovens may need to
self-clean again or for a longer period of time.
• Close the oven door.
• Touch the
“CLEAR OFF”
pad. Allow the oven to
cool.
• Touch the
“CLEAR OFF”
pad. Allow the oven to
cool for one hour. Put the oven back into
operation.
• Check the main gas shut-off valve or the oven gas
shut-off valve(see “Surface burners light but oven
burner does not” column).
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
• Apply a small amount of vegetable oil to a paper
towel and wipe the edges of the oven racks with
the paper towel. Do not use lubricant sprays.
• Reset the clock. If the oven was in use, you must
reset it by touching the
“CLEAR OFF”
pad,
setting the clock and resetting any cooking
function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the “USING THE SELF-
CLEANING OVEN” section.
• This is temporary.
• This is normal. The convection fan will shut off if
the door is opened.