LG LSC23924SW Owner's Manual - Page 18

USING YOUR REFRIGERATOR ICE PLUS Press this button once to activate the ice plus function. The ICE PLUS icon on the display panel will illuminate when activated. The ice plus function runs the freezer compartment at the coldest settings for a 24 hour period to increase ice making. Press the button again to cancel the Ice Plus function. LOCK The Lock button deactivates the temperature controls and dispenser functions. Press and hold this button for 3 seconds or until the Lock indicator light is lit. To disable the Lock function, press and hold the filter button for 3 seconds or until the Lock indicator light is off. FILTER (filter replacement cycle) There is an indicator light for the water filter cartridge on the dispenser that will blink to indicate it is time to change the water filter. Water filters usually need to be replaced once every six months. After replacing the filter, press and hold the Filter Reset button for 3 seconds to turn off the filter status light. Display Off Mode This display lights up and stays lit for 60 seconds when the refrigerator is plugged in. Then all the display lights go off except for the selected dispenser icon (water, or cubed or crushed ice). In this Display Off mode, the display only lights when the door is opened or the display button is pressed. To deactivate the Display Off Mode, press and hold the Freezer Temp and Ice Plus buttons for 5 seconds until the tone sounds. Repeat this procedure to reactivate the Display Off Mode. ADJUSTING CONTROL SETTINGS Give the refrigerator time to cool down completely before making final adjustments. It is best to wait 24 hours before doing this. The initial settings mentioned in CONTROL PANEL FEATURES section should be correct for normal household refrigerator use. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm. The refrigerator control functions as the thermostat for the entire appliance (refrigerator and freezer sections). The colder the setting, the longer the compressor will run to keep the temperature colder. The freezer control adjusts the cold air flow from the freezer to the refrigerator. Setting the freezer control to a lower temperature keeps more cold air in the freezer compartment to make it colder. If you need to adjust temperatures in the refrigerator or freezer, start by adjusting the refrigerator and allow 24 hours for the temperature to stabilize. If it is too warm or too cold, then adjust the freezer control. Use the settings listed in the chart below as a guide. Always remember to wait at least 24 hours between adjustments. CONDITION/REASON: REFRIGERATOR section is too warm Opening the door often Adding a large amount of food Room temperature is very warm FREEZER section is too warm/ ice is made too slowly Opening the door often Adding a large amount of food Room temperature is very low (not cycling often enough) Using ice frequently Air vents blocked by objects REFRIGERATOR section is too cold Controls not set correctly for your conditions FREEZER section is too cold Controls not set correctly for your conditions RECOMMENDED ADJUSTMENT: Adjust the REFRIGERATOR setting to the next highest number and wait 24 hours, then check Adjust the FREEZER setting to the next highest number and wait 24 hours, then check Remove any objects blocking blocking air flow. Adjust the REFRIGERATOR setting to the next highest number and wait 24 hours, then check Adjust the FREEZER setting to the next highest number and wait 24 hours, then check 18