LG LSC26905TT Owner's Manual - Page 20

How to Dismantle Parts - water assembly

Page 20 highlights

Care and Maintenance Care and Maintenance How to Dismantle Parts NOTE • Dismantling is done in the reverse sequence of assembly. Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged. Freezer Compartment Lamp Remove cover by pressing upward on bottom and rotating outward . Turn the bulb counterclockwise. Max. 40 Wbulb for refrigerator is used and can be purchased at a service center. Dispenser Lamp Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W bulb for refrigerator is used and can be purchased at a service center. Freezer Compartment Shelf To remove a shelf, Lift the left part of the shelf a bit. Lift it to the direction , push the right part to the direction , and take it out. Door Rack and Lift the door rack holding both sides and Support pull it out to direction. Ice Storage Bin Lift the ice shelf as shown in the right gure and pull it out . 2 Hold the ice storage bin as shown in the right gure and pull it out while slightly lifting it . 1 After Dispenser Is Used It is recommended not to dismantle the ice storage bin unless it is necessary. Use both hands to remove the ice bin to avoid dropping it. If the ice bin does not slide into place easily, twist the drive device slightly. The water collector has no self-draining function. It should be cleaned regularly. Remove the cover by pulling the front side of water collector cover and dry it with a cloth. 20 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29

Care and Maintenance
How to Dismantle Parts
Freezer
Compartment
Lamp
Dispenser Lamp
Freezer
Compartment
Shelf
Door Rack and
Support
Ice Storage Bin
After Dispenser
Is Used
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
To remove a shelf, Lift the left part of the
shelf a bit. Lift it to the direction
, push the
right part to the direction
, and take it out.
Lift the door rack holding both sides
and
pull it out to
direction.
Lift the ice shelf as shown in the right figure
and pull it out
.
The water collector has no self-draining
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
Hold the ice storage bin as shown in the right
figure and pull it
out while
slightly lifting it
.
Dismantling is done in the reverse sequence of assembly.
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
NOTE
Remove cover by pressing upward on bottom
and rotating outward
.
Turn the bulb counterclockwise. Max. 40 W
bulb
for refrigerator is used and can be purchased at
a service center.
1
2
Care and Maintenance
It is recommended not to dismantle the ice
storage bin unless it is necessary.
Use both hands to remove the ice bin to avoid
dropping it.
If the ice bin does not slide into place easily,
twist the drive device slightly.
6
20