LG LSC26905TT Owner's Manual - Page 8

Door removal - water

Page 8 highlights

Installation Warning Remove Lower Cover and Water Feed Tube Remove the Freezer Compartment Door Door removal Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Remove the lower cover by lifting upward, and then pull up the water feed tube while pressing area shown in the figure to the right. Water Feed Tube Lower Cover NOTE • If a tube end is deformed or abraded, trim the part away. Disconnecting the tube under the door causes about 1.5 litters water to flow out. Please put a large container at end of tube to prevent water from draining on to the floor. Hinge 1) Remove the hinge cover by loosening the Cover screws. Disconnect all connections except the ground line. Upper Hinge Connection Wires Earth Line 2) Remove the keeper by rotating it counter clockwise and then lifting the upper hinge up . Keeper Upper Hinge Remove the Refrigerator Door NOTE • When removing the upper hinge, be careful that the door does not fall forward . 3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the water feed tube to be completely pulled out. Lower hinge NOTE • After removing the door, take it into the kitchen where you are installing the refrigerator. Lay it down on a blanket and be careful to avoid damaging the water feed tube. 1) Loosen the hinge cover screws and remove the cover. Remove connection wire. 2) Remove keeper by rotating it clockwise and then remove the upper hinge by lifting it up . Connection Wires Upper Hinge Keeper 3) Remove the refrigerator compartment door by lifting it up. 8 6 Lower Hinge

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29

Door removal
Failure to do so could result in death or serious injury.
If your entrance door is too narrow for the
refrigerator to pass through, remove the
refrigerator door and pass the refrigerator laterally.
Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing.
Remove the lower cover by lifting upward, and
then pull up the water feed tube while pressing
area
²
shown in the figure to the right.
Remove Lower
Cover and
Water Feed Tube
Warning
Remove the
Freezer
Compartment
Door
Remove the
Refrigerator
Door
Installation
1) Remove the hinge cover by loosening the
screws. Disconnect all connections except
the ground line.
2) Remove the keeper by rotating it counter
clockwise
²
and then lifting the upper
hinge up
³
.
3) Remove the freezer compartment door by
lifting it upward. This time, the door should
be lifted enough for the water feed tube to
be completely pulled out.
1) Loosen the hinge cover screws and remove
the cover. Remove connection wire.
2) Remove keeper by rotating it clockwise
²
and then remove the upper hinge by lifting
it up
³
.
3) Remove the refrigerator compartment door
by lifting it up.
If a tube end is deformed or abraded, trim the part away.
Disconnecting the tube under the door causes about 1.5 litters water to flow out. Please
put a large container at end of tube to prevent water from draining on to the floor.
NOTE
When removing the upper hinge, be careful that the door does not fall forward .
NOTE
After removing the door, take it into the kitchen where you are installing the
refrigerator. Lay it down on a blanket and be careful to avoid damaging the water
feed tube.
NOTE
Lower Cover
Lower hinge
Lower Hinge
Keeper
Water Feed Tube
Connection
Wires
Connection
Wires
Hinge
Cover
Upper Hinge
Upper Hinge
Keeper
Upper Hinge
Earth Line
8