LG LSC27921SW Owner's Manual - Page 23

TROUBLESHOOTING GUIDE UNDERSTANDING SOUNDS YOU MAY HEAR Your new refrigerator may make sounds that your old one did not make. Because the sounds are new to you, you might be concerned about them. Most of the new sounds are normal. Hard surfaces, like the floor, walls and cabinets, can make the sounds seem louder than they actually are. The following list describes the kinds of sounds and what may be making them. • The defrost timer will click when the automatic defrost cycle begins and ends. The thermostat control (or refrigerator control, depending on the model) will also click when cycling on and off. • Rattling noises may come from the flow of refrigerant, the water line, or items stored on top of the refrigerator. • Your refrigerator is designed to run more efficiently to keep your food items at the desired temperature. The high efficiency compressor may cause your new refrigerator to run longer than your old one, and you may hear a pulsating or high-pitched sound. • You may hear the evaporator fan motor circulating the air through the refrigerator and freezer compartments. • As each cycle ends, you may hear a gurgling sound due to the refrigerant flowing in your refrigerator. • Contraction and expansion of the inside walls may cause a popping noise. • Water dripping on the defrost heater during a defrost cycle may cause a sizzling sound. • You may hear air being forced over the condenser by the condenser fan. • You may hear water running into the drain pan during the defrost cycle. Problem REFRIGERATOR DOES NOT OPERATE Possible causes Solutions • The power supply cord is unplugged. • A household fuse has blown or circuit breaker tripped. •The refrigerator control is set to the OFF position. •Refrigerator is in the defrost cycle. • Firmly plug the cord into a live outlet with proper voltage. • Replace the fuse or reset the circuit breaker. • Refer to CONTROL PANEL FEATURES. • Wait about 30 minutes for defrost cycle to end. VIBRATION OR RATTLING NOISE LAMPS DO NOT WORK • The refrigerator is not resting solidly on the floor. • The power supply cord is unplugged. • Light bulb is loose in the socket. • Light bulb has burned out. • Floor is weak or uneven or leveling legs need adjusting. See DOOR ALIGNMENT Section. • Firmly plug the cord into a live outlet with proper voltage. • Unplug the refrigerator. Gently remove the bulb and reinsert. Then plug in refrigerator and reset the refrigerator control. • Replace with an appliance bulb of the same wattage, size and shape available at your local hardware store ( See the LAMP REPLACEMENT section). Unplug the refrigerator prior to replacement. 24