LG LSC27921SW Owner's Manual - Page 8

REFRIGERATOR INSTALLATION Reinstalling the left (freezer) door (2) (1) (4) (5) (6) (7) Type 1 (3) (7) (5) (6) Rivet Type 2 1. Feed the water tubes through the lower hinge pin and place the door onto the lower hinge pin. 2. Fit top hinge (6) over hinge lever latch (7) and into place. Rotate lever (5) clockwise to secure hinge. NOTE: Regardless of hinge lever type, reinstallation process is the same. 3. Install the grounding screw (4) and connect all the wire harnesses (3). 4. Hook tab on door switch side of cover (2) under edge of wire opening in cabinet top. Position cover into place. Insert and tighten cover screw (1). 5. Reconnect the water tubes by inserting the tubes into the connectors. Collet Tube Insert Line DOOR ALIGNMENT Remove the base grille before adjusting the doors. See BASE GRILLE INSTALLATION for reference. Two methods of door alignment are available based on the amount of adjustment needed and installation requirements. Type 1 Adjusting tool: Flat blade screwdriver If the freezer compartment door is lower than the refrigerator compartment door, level them by inserting a flat blade screwdriver into the groove of the left leveling leg and rotating it clockwise. Height difference Height difference Height difference Right leveling leg CC FF C F H Type 2 Adjusting tools: 5/16" (8 mm) wrench and 3/4" (19 mm) wrench Height difference Keeper Nut Wrench Height Adjustment Up difference hinge pin Down CC F F C HF Using a 3/4" (19 mm) wrench, turn the keeper nut clockwise to loosen the keeper nut. Using a 5/16" (8 mm) wrench, turn the adjustment hinge pin clockwise or counterclockwise to level the refrigerator and freezer door. After setting level door, turn the keeper nut counterclockwise to tighten. CAUTION: Do not overtight the door adjustment screw. The hinge pin can be pulled out. (Adjustable range of height is a maximum of 1/2" (1.27 cm)). AFTER LEVELING THE DOOR HEIGHT Confirm all legs are in contact with the floor. Left leveling leg Height difference CC FF C F H If the freezer compartment door is higher than the refrigerator compartment door, level them by inserting a flat blade screwdriver into the groove of the right leveling leg and rotating it clockwise. 9