LG LSC27935SB Owner's Manual - Page 15

USING YOUR REFRIGERATOR LIGHT/FILTER LIGHT/FILTER The LIGHT/FILTER button controls the lamp in the dispenser, resets the water filter replacement indicator when the filter has been replaced. The water filter needs replacement once every six months. Filter month indicator becomes "0" to let you know when replace filter. Press and hold the LIGHT/FILTER button for more than 3 seconds to reset the filter month indicator to six after the water filter has been replaced. 6 Door Alarm Indicator This indicator shows that the door-open warning alarm is activated. 7 Water Filter Status This light shows the filter's status. See the filter's configurations. 8 Lock Status This light shows the actual status of the control panel, in which the lock function is on. ALARM/LOCK ALARM/LOCK 3 SEC Press this button to control the door-open alarm. Press and hold the ALARM/LOCK button for 3 seconds to lock the dispenser and all the other control panel functions. Press and hold again for 3 seconds to unlock. The ALARM/LOCK button also controls the door alarm that sounds three times in 30 seconds intervals when a compartment door is left open for more than 60 seconds. The alarm stop sounding when the door is closed. Press the ALARM/LOCK button once to activate or deactivate the door alarm function. DISPLAY OFF MODE To activated Display Off Mode press and hold ICE PLUS and FREEZER key over 5 seconds until lights will turn on and after 20 seconds of inactivity the lights will turn off automatically. To exit Display Off Mode press and hold ICE PLUS and FREEZER key over 5 seconds until lights will tilt. Display Off Mode does not affect the temperature control settings of the unit. DIAGNOSIS FUNCTION (FAILURE DETECTION) Diagnosis function automatically detects failure during the normal use of refrigerator. If you refrigerator fails, do not turn off the power. Instead, contact a local Authorized service center or call our support line for assistance. Turning off the appliance will make it more difficult for the service technician to determine the problem. ADJUSTING CONTROL SETTINGS Give the refrigerator time to cool down completely before making final adjustments. It is best to wait 24 hours before doing this. The initial settings mentioned in "Control Panel Features" section should be correct for normal household refrigerator use. The refrigerator control functions as the thermostat for the entire appliance (refrigerator and freezer sections). The colder the setting, compressor will the longer the run to keep the temperature colder. The freezer control adjusts the cold air flow from the freezer to the refrigerator. Setting the freezer control to a lower temperature keeps more cold air in the freezer compartment to make it colder. ICE TYPE 1 CRUSH CUBE 1 Ice Type Indicator Shows the type of ice, crushed or cube, or water that the dispenser will dispense. 2 2 Freezer Temperature Shows the temperature in the 3 freezer, Celsius or Fahrenheit. 4 ICE PLUS 3 Refrigerator Temperature 5 HOLD 3 SECS MONTH Shows the temperature in 7 the refrigerator, Celsius or 6 8 Fahrenheit. 4 Ice Plus When this button is on the screen will show this has been activated. 5 Dispenser Light When this button is in function on the light will show this has been activated. When the dispenser light is on the display will indicate this feature. If you need to adjust temperatures in the refrigerator or freezer, start by adjusting the refrigerator and allow 24 hours for the temperature to stabilize. If it is too warm or too cold, then adjust the freezer control. Use the settings listed in the chart below as a guide. Always remember to wait at least 24 hours between adjustments. CONDITION/REASON: REFRIGERATOR section is too cold • Controls not set correctly for your conditions FREEZER section is too cold • Controls not set correctly for your conditions RECOMMENDED ADJUSTMENT: Adjust the REFRIGERATOR setting to the next lowest number and wait 24 hours, then check. Adjust the FREEZER setting to the next lowest number and wait 24 hours, then check. 14