LG LSC27935SB Owner's Manual - Page 21
Filter, Warning, Caution
View all LG LSC27935SB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
FILTER Performance Data Sheet Models Number 5231JA2006E Use with replacement cartridge 5231JA2006E This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI 42. System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor and Nominal Particulate Class III. * Contaminant Reduction Nominal Particulate Class I Particle size: ›0.5 to ‹1 um Chlorine taste and odor Average Influent 5600000 1,9 mg/L Influent Challenge Concentration. Units apply to each row Product Water At least 10,000 915 particles/ml 2,0 mg/L ± 10% 0,07 Average % Reduction 96 96,4 NSF Reduction Requirements ≥ 85% ≥ 50% Max Effluent mg/L 470000 0.05 mg/L Min % Reduction 91.6% 97.4% NSF Test 511032-03 511032-03 * To a capacity of 300 gallons (1.135 L). * Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Application Guidelines / Water Supply Parameters Water Pressure 20 - 120 psi (138 - 827 kPa) Water Temperature 33 ºF - 100 ºF (0,6 ºC - 38 ºC) Service Flow 0,5 gpm (1,9 lpm) WARNING To reduce the risk associated with ingestion of contaminants due to use with water that is micro biologically unsafe or of unknown quality. Do not use with water that is micro biologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems must be installed and operated in accordance with manufacturer's recommended procedures and guidelines. CAUTION To reduce the risk of property damage due to water leakage: • Read and follow Use instructions before installation and use of this system. • Install on COLD water lines only. Comply with all state and local plumbing codes. • Company with all state and local plumbing codes. Never install or operate where inlet water pressure may exceed 125 psi (862 kPa). • Protect filter from freezing. Remove filter in temperatures below 34 °F (1 °C). • Replace cartridge at specified service interval. Cartridge MUST be replaced at least every 6 months. • After replacing the water filter cartridge, dispense 2,5 gallons (9,46 liters) of water to purge the system, depressing and releasing the dispenser pad in cycles of 30 seconds ON and 60 seconds OFF. Discard the purged water. To purchase or replace water filters call your Service Center. Refer to the Warranty Card to obtain the telephone number of the Service Center near you and ask for part no. 5231JA2006E. 20