LG LSES302ST Owner's Manual - Page 11

SURFACE CONTROLS COOKING ENGLISH SETTING SURFACE CONTROLS Use to operate the surface elements. The control knobs can be set anywhere between HI and LO. ➊ Place pan on surface element. ➋ P ush in and turn the knob in either direction to the desired heat setting. ➌ There are element indicator lights above the each knob on the control panel. When any control knob is turned on, the light will glow. NOTE: The Control Panel is marked to identify where the element is. OFF ON ➍ A fter cooking, turn knob to OFF HOT SURFACE INDICATOR A Hot Surface indicator light will glow when the surface is too hot to touch because of the heating element. It will remain on after the element is turned off and the surface has cooled to approximately 150 deg F. CAUTION • DO NOT touch surface elements until it has cooled down sufficiently. - The surface elements may still be hot and burns may occur. USING THE ELEMENT To turn on a SINGLE 2 2 surface unit: (Left Rear, Right Rear) 1 ➊ Push the knob in. ➋ T urn the knob in either direction to the setting you want. The control knob clicks when it Is positioned at bo2th OFF 2and HI. 1 2 2 2 2 1 1 CAUTION • NEVER leave food unattended at high or mediumhigh setting. - B oil overs can cause smoke. Greasy spillovers may catch on fire. 2 2 1 T(Loetfut rFnroonn2t)aSingDle 2U2AL s2uDruafl ace unit: 12 1 2 There is one duaA l element loBcated in the left front position. This allows you to change the size of element. 1 ➊ Push the knob in. ➋-A ➋-B T urn the knob counterclockwise to the SINGLSinEgle surface uDnuailt settings. T urn the knob clockwise to the DUAL surface unit settin2gs 2 A B S1ingle A 2 A SinglDeual 2B 2 A B Dual 2 B 1 1 Heating with inner (smaller)element only A A A Heatin2g with b2oth elements together 1 B Single B B2 A 11 1