LG LSXC22396S Owners Manual - Page 49

ENGLISH, Low house water supply pressure.

Get LG LSXC22396S PDF manuals and user guides View all LG LSXC22396S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

ENGLISH TROUBLESHOOTING 49 Ice & Water Problem Possible Cause Infrequent use of the dispenser. Ice is not dispensing. The delivery chute is clogged with frost or ice fragments. The dispenser display is locked. Ice bin is empty. Solutions Infrequent use of the ice dispenser will cause the cubes to stick together over time, which will prevent them from properly dispensing. Check the ice bin for ice cubes clumping/sticking together. If they are, break up the ice cubes to allow for proper operation. Eliminate the frost or ice fragments by removing the ice bin and clearing the chute with a plastic utensil. Dispensing cubed ice can also help prevent frost or ice fragment buildup. Press and hold the Lock button for three seconds to unlock the control panel and dispenser. It may take up to 24 hours for each compartment to reach the desired temperature and for the icemaker to begin making ice. Make sure that the shutoff (arm/ sensor) is not obstructed. Once the ice supply in the bin has been completely exhausted, it may take up to 90 minutes before additional ice is available, and Approximately every six months. Water is dispensing slowly. When the water dispenser output decreases. When the ice cubes are smaller than normal. is used. Low house water supply pressure. water pressure below the minimum amount and result in icemaker issues. If the problem persists, it may be necessary to contact a plumber. The water pressure must be between 20 and 120 psi on may be necessary to contact a plumber. New installation or water line recently connected. Water is not dispensing. The dispenser panel is locked. The dispenser is not set for water dispensing. minutes) to remove trapped air and contaminants from the system. Do not dispense the entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF. Press and hold the Lock button for three seconds to unlock the control panel and dispenser. The dispenser can be set for ice or water. Make certain that the control panel is set for the proper operation. Press the Water button on the control panel to dispense water.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
49
TROUBLESHOOTING
Ice & Water
Problem
Possible Cause
Solutions
Ice is not
dispensing.
Infrequent use of the dispenser.
Infrequent use of the ice dispenser will cause the cubes
to stick together over time, which will prevent them from
properly dispensing. Check the ice bin for ice cubes
clumping/sticking together. If they are, break up the ice
cubes to allow for proper operation.
The delivery chute is clogged with
frost or ice fragments.
Eliminate the frost or ice fragments by removing the
ice bin and clearing the chute with a plastic utensil.
Dispensing cubed ice can also help prevent frost or ice
fragment buildup.
The dispenser display is locked.
Press and hold the
Lock
button for three seconds to
unlock the control panel and dispenser.
Ice bin is empty.
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker
to begin making ice. Make sure that the shutoff (arm/
sensor) is not obstructed. Once the ice supply in the
bin has been completely exhausted, it may take up
to 90 minutes before additional ice is available, and
Water is
dispensing
slowly.
Approximately every six months.
When the water dispenser output decreases.
When the ice cubes are smaller than normal.
is used.
water pressure below the minimum amount and result
in icemaker issues. If the problem persists, it may be
necessary to contact a plumber.
Low house water supply pressure.
The water pressure must be between 20 and 120 psi on
may be necessary to contact a plumber.
Water is not
dispensing.
New installation or water line
recently connected.
minutes) to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon amount
continuously. Depress and release the dispenser pad for
cycles of 30 seconds ON and 60 seconds OFF.
The dispenser panel is locked.
Press and hold the
Lock
button for three seconds to
unlock the control panel and dispenser.
The dispenser is not set for water
dispensing.
The dispenser can be set for ice or water. Make certain
that the control panel is set for the proper operation.
Press
the
Water
button on the control panel to dispense
water.
ENGLISH